User manual

SealSeal

Seal

Fitting the Hob into the Worktop

Carry out the building in of the hob as follows:

1. place the seals supplied with the hob on the front edge of the cut out.

Then, place them at 86 mm from the side edges and at 10 mm from the

rear edge, as shown in the diagram,

taking care that the seals meet

without overlapping.

2. Place the hob in the cut out, taking

care that it is centred.

3. Fix the hob with the relevant fixing

clamps, supplied with the injectors

kit (see diagram). When the screws

have been tightened, the excess seal

can be removed.

The edge of the hob forms a double seal

which prevents the ingress of liquids.