825 D / 8259 D Dunstabzugshaube Fume Extractor Hood Hotte aspirante Afzuigkap Cappa aspirante Montage- und Gebrauchsanweisung Installation and Operating Instructions Instructions de montage et mode d'emploi Montage- en gebruiksaanwijzing Istruzioni di montaggio ed istruzioni per l'uso ÁðïññïöçôÞñáò õäñáôìþí
Contents Introduction 20 Extractor version Filter version 20 21 Electrical connections 22 Safety warnings for electrician 22 Technic Details 23 Installation 24 Safety warnings for kitchen unit installer Installation 24 26 Hood Operation 28 Safety warnings for user 29 Maintenance and care 30 Metal grease filter Open the metal grease filter Carbon filter Changing the light bulb 30 30 31 32 Cleaning 33 Special accessories 33 Technical assistance service 33 Printed on recycled paper.
Introduction Extractor version ● The hood is supplied as an extractor unit and can also be used with a filtering function by fitting activated carbon filters (special accessory). ● You will need original AEG activated carbon filters for this function (see Special Accessories). ● The air is forced out through a hose fitted to the top of the hood A. Fig. 1. ● The outlet hose must have a diameter of 120 mm (special accessory) for the filtering version.
Filter version ● The air is filtered through an activated carbon filter and passed back into the kitchen through the top outlet duct grids. ● You will need an original AEG KF 825 activated carbon filter for the filtering function. (See Special Accessories). ● Fix the deflector with two screws Ø3,5x6,5. Fig. 2. Fig.
Electrical connections Safety warnings for electrician It must be ensured that the voltage and current indicated on the rating plate agree with the voltage of the user to electricity supply. If the appliance has been equipped with a mains lead with a moulded-on type plug, the following regulations must be comply with: The plug moulded on to the lead incorporates a fuse. For replacement, use a 5 amp BS1362 fuse. Only ASTA approved or certified fuses should be used.
Electrical connection for the UK Appliances with 2 wires The appliance must be connected to fixed wiring with a double pole switched fused spur outlet with or without pilot lamp. We strongly recommend the appliance to be connected only by a qualified electrician who is a member of the NICEIC who will comply with the IEE and any local regulations. NOTE: The terminology DOUBLE POLE means that both the live and the neutral supplies are switched and disconnected at the same time.
Technic Details Dimensions (825 D): Height x Width x Depht (in cm) Dimensions (8259 D): Height x Width x Depht (in cm) 84-117 x 59,9 x 51.5 84-117 x 89,9 x 51.
Installation Safety warnings for kitchen unit installer ● When used as an extractor unit, the hood must be fitted with a 120mm diameter hose. ● If the fumes must be forced out through the wall, you must obtain a MKZ sizable wall exhaust pipe (with external exhaust and air intake), E-Nr.- 610 899 004 (Ø 120 mm) which is one of our optional parts.
● Hoods can only be used safely with appliances connected to a chimney if the room and/or flat (air/environment combination) is ventilated from outside using a suitable ventilation hole approximately 500-600 cm 2 large to avoid the possibility of a depression being created during operation of the hood. If you have any doubts, contact the relevant controlling authority or building inspectors office.
Installation - Fig. 3 ● Put the template onto the wall (1) and drill two Ø12mm holes (2). ● Fit two hooks (3) on the drilled holes. ● Hang the hood on the hooks and adjust the position of the hood using the two screws on the bottom of the hooks (5). ● Remove the metal filters (4) and mark two points (6). Remove the hood and drill two Ø8mm holes on the marked points. Fit two Ø8mm wall dowels (7), Hang again the hood and fix the hood definitively with two screws 5X45 (8).
Ø 120 mm Fig.
Hood Operation ● The hood is fitted with a variable speed motor. The most effective use of the hood is obtained by switching it on a few minutes before you start cooking and leaving it on a for approximately 15 minutes after you have finished, thus ensuring all cooking odours are eliminated.
Safety warnings for user ● Never leave a cooking hob or ring on without a pot or pan on top of it, to avoid the possibility of excess heat damaging the unit. Gas, oil or coal cooker flames in particular should never be left uncovered. ● Special care should be taken when using deep fat fryers since the oil in them can overheat and burst into flames. ● The risk of a fat fire increases when using dirty oil. ● It is extremely important to note that overheating can cause a fire.
Maintenance and care ● The hood must always be disconnected from the mains power supply before beginning any maintenance work. Metal grease filter ● The purpose of the grease filters is to aspirate grease particles which form during cooking and it must always be used, either in the external evacuation or internal recycling function. Attention: the metal grease filters must be removed and washed, either by hand or in the dishwasher, every four weeks.
Carbon filter ● The activated carbon filter should only be used if you want to use the hood in its filtering function. ● To do this you will need an original AEG activated carbon filter (see special accessories). ● This filter cannot be cleaned or reused. ● As a general rule, the activated carbon filter should be changed once every four months. ● Mounting Fig.
Wa r n i n g ● Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. ● The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Changing the light bulb ● Disconnect the unit from the mains power supply. ● Remove the lamp cover.
Cleaning ● Warning: always disconnect the hood from the mains power supply before cleaning it. Never insert pointed objects in the motors protective grid. ● Wash the outside surfaces using a delicate detergent solution. Never use caustic detergents or abrasive brushes or powders. ● Only ever clean the switch panel and filter grille using a damp cloth and delicate detergents. ● It is extremely important to clean the unit and change the filters at the recommended intervals.