8260 D Konyhai páraelszívó Szerelési és használati útmutató
Kedves Vásárló ! Kérjük, hogy figyelmesen olvassa el ezt a Szerelési és használati útmutatót. Mindenek elõtt a Biztonságra vonatkozó fejezetben leírtakat tartsa szem elõtt. Az útmutatót gondosan õrizze meg, hogy bármikor kéznél legyen, ha adott esetben szüksége lesz rá. Ha a készüléket eladja, vagy elajándékozza, akkor ezt az útmutatót is adja át az új tulajdonosnak. Amennyiben a készülék mûködése közben hibát észlel, akkor forduljon a jótállási jegyben megjelölt szervizhez, vagy a Vevõszolgálathoz.
Tartalomjegyzék Általánosságok 4 Elszívó üzemmód Keringtetõ üzemmód 4 4 Elektromos csatlakoztatás 5 Biztonsági útmutatások az elektromos szereléshez 5 Mûszaki adatok 6 Szerelés 7 Biztonsági útmutatások konyhai bútorba való szereléshez Szerelés 7 8 A páraelszívó használata 13 Biztonsági útmutatások a készülék használatához 13 Karbantartás és ápolás 14 Fém zsírszûrõ A fém zsírszûrõ nyitása Szénszûrõ Az izzólámpa cseréje 14 14 14 16 Tisztítás 17 Különtartozékok 17 Vevõszolgálat 17
Általánosságok Elszívó üzemmód • A páraelszívót a gyártó elszívó üzemmódra állítva szállítja. Egy aktív szénszûrõ (különtartozék) behelyezésével a készüléket keringtetõ üzemmódban is lehet használni. • Ehhez az üzemmódhoz eredeti AEG aktív szénszûrõre (lásd Különtartozékok c. rész) van szükség. • A levegõ a kivezetõ csonkhoz (A) csatlakoztatott csövön át a szabadba távozik (1. ábra). • Az elszívó üzemmódban az elszívócsõ átmérõjének 150 mm-nek kell lenni (különtartozék).
2. ábra Elektromos csatlakoztatás Biztonsági útmutatások az elektromos szereléshez A készülék csatlakoztatása elõtt ellenõrizni kell, hogy a készülék adattábláján megadott értékek megegyeznek-e a felszerelés helyén lévõ elektromos hálózat adataival. Ha készülék csatlakozó dugóval van szerelve, akkor azt csak szabályosan szerelt, védõérintkezõs dugaszoló aljzatba szabad csatlakoztatni.
Mûszaki adatok Méretek (8260 D) magasság x szélesség x mélység (mm) 800-1350 x 598 x 470 Együttes névleges teljesítmény 200 W Szellõztetõ motor 2 x 155 W Világítás 2 x 20 W Hálózati kábel hossza: 100 cm Légszállítási fokozat IEC 61591 szerint Elszívó fokozat 1 200 m3/h 2 290 m3/h 3 420 m3/h Keringtetõ fokozat 1 160 m3/h 2 250 m3/h 3 360 m3/h Szívórendszer ∅ 150 mm Ez a készülék megfelel az alábbi EWG irányelveknek: - 73/23 EWG 19/02/73 (kisfeszültség) - 89/336 EWG 02/05/89 és változ
Szerelés Biztonsági útmutatások konyhai bútorba szereléshez • Az elszívó üzemmódban alkalmazott elszívócsõ átmérõjének 150 mm-esnek kell lenni. Ha a konyhai párát a külsõ falon, vagy a tetõn át a szabadba vezeti és adott esetben már rendelkezésre áll egy 125 mm átmérõjû elszívócsõ, akkor a mellékelt 150/125 mm méretû csõszûkítõt kell alkalmazni. A csõszûkítõvel együtt a 125 mm-es kivezetõ tömlõt (különtartozék ABS 125, E-Nr. 942 118 612) is fel lehet szerelni.
Szerelés - 3. ábra • A szimmetria tengelyt elõ kell rajzolni, a fúrósablont (1) a falra kell helyezni és a két átvezetõ furatot be kell jelölni, majd utána a furatokat ki kell fúrni (2 x ∅ 8 mm) (2). • Mindkét fali tiplit az akasztóval be kell illeszteni (3). • Az elszívót a kéménynél fel kell akasztani és az állítócsavarok segítségével vízszintesen ki kell igazítani (4). • A zsírszûrõt (5) el kell távolítani és a két furatot be kell jelölni (6) a falon.
3.
Szerelés Tartozékok/szerelési anyagok 6 tipli S8 x 6 (∅ 8) 6 facsavar 5 x 45 x 6 (5 x 45) 2 lemezcsavar 2,9 x 13 x 2 (2,9 x 13) 4 lemezcsavar 2,9 x 6,5 x 4 (2,9 x 6,5) 4 lemezcsavar 3,5 x 13 x 4 (3,5 x 13) 2 fémakasztó x2 1 kéménytartó x1 2 csõbilincs x2 1 csõszûkítõ 150/125 mm x1 10
A páraelszívó használata • A páraelszívó egy szabályozható fordulatszámú motorral van felszerelve. A páraelszívót már a fõzés megkezdése elõtt célszerû bekapcsolni és kb. 15 percig még a fõzés befejezése után is bekapcsolva hagyni, hogy a konyhai szagok minél jobban eltávozhassanak. A kapcsoló a készülék elõlapján található. • Világítás kapcsoló: A világítással kialakított páraelszívó lámpájának be- és kikapcsolására szolgál. • Motor kapcsoló: Ezzel a kapcsolóval lehet az elszívó motort kikapcsolni.
Karbantartás és ápolás • Bármilyen karbantartási munkálat megkezdése elõtt a páraelszívót le kell választani az elektromos hálózatról. Fém zsírszûrõ • A fém zsírszûrõ feladata a fõzés közben keletkezõ zsírrészecskék elszívása és eltávolítása a levegõbõl, függetlenül attól, hogy a készülék elszívó-, vagy keringtetõ üzemmódban dolgozik. A fém zsírszûrõt minden 4 hónap után ki kell venni és mosogatógépben, vagy kézzel alaposan meg kell tisztítani.
aktivizáláshoz felsõ- és alsó fûtést állítson be max. 100oC-ra állítva a hõfokszabályzót és kb. 10 percig szárítsa a szûrõt. Kb. 3 év után a szénszûrõt ki kell cserélni, mert ezután már erõsen lecsökken a páraelszívó felvevõképessége. • Szerelés • A szénszûrõ tartót az elszívó belsejében a mellékelt 4 db csavarral kell felerõsíteni. • Helyezze a szénszûrõt az egyik oldalára, egy könnyed forgatással helyezze be a szûrõtérbe és a piros billentyûkkel (A) rögzítse. 5.
Figyelmeztetés • A készülék és a szûrõ tisztításnál, illetve a szûrõ cserénél az elõzõekben elõírtak be nem tartása tûzveszélyt okozhat, ezért ezeknek a szempontoknak a pontos betartására nagyon vigyázzon. • A gyártó a szakszerûtlen használatból, vagy a nem megfelelõ karbantartásból eredõ károkért nem vállal semmiféle felelõsséget.
Tisztítás • Figyelem: A páraelszívó tisztításának megkezdése elõtt áramtalanítani kell a készüléket. Tilos hegyes tárggyal benyúlni a motor védõrácsába. • A külsõ részeket enyhén mosogatószeres, langyos vízzel tisztítsa meg. Vegyi tisztítószert, súrolószert, vagy dörzskefét nem szabad használni, mert károsodik a készülék. • A kezelõpanelt és a zsírszûrõ rácsot csak enyhén mosogatószeres, langyos vízbe mártott puha ruhával törölje tisztára.