Operating instructions

Fig. 22 : Removing the UPS front cover

6. Disconnect the internal battery connector and EBM battery

connector. If the EBM cable is not connected to an EBM,

unclip the EBM cable and move it to the left out of the way,

see Figure 23.

7. Remove and retain the two screws on the battery cover

plate, see Figure 23.

Fig. 23 : Disconnecting the UPS internal batteries;

Removal of the battery cover plate

8. Grasp an edge of the battery cover plate and pull it out

gently. Remove and retain the battery cover plate. Figure 23

shows the location of the battery cover plate.

Carefully pull the handle on the battery tray and slide the

battery package slowly out onto a flat, stable surface; use

two hands to support the battery package, see Figure 24.

Pay attention to the weight of the battery system, especially

at the more powerful models.

This part stays

in the rack!