User manual

9
Vorgehensweise
1. Sockelblende (D) nach vorn
abziehen.
2. Türlagerabdeckung (F) von links nach
rechts umsetzen.
3. Unteres Türlager (E) abschrauben.
4. Tür nach unten abnehmen.
5. Beide Lochabdeckungen links mit
Schraubendreher herausdrehen und
auf rechter Seite eindrehen.
6 . Obere Lagerzapfen herausdrehen
und auf linke Seite umsetzen.
7. Kunststoff-Abdeckstöpsel auf Tür
oben links mit Hilfe eines kleinen
Schraubendrehers heraushebeln und
auf rechte Seite umsetzen.
8. Tür in oberen Lagerzapfen einsetzen.
9. Unteres Türlager in Tür unten links
einsetzen.
10. Sockelblende (D) aufsetzen.
11. Türgriffe abnehmen und auf
gegenüberliegender Seite befestigen.
Mit einem Senkstift die Plastikstöpsel
auf der gegenüberliegenden Seite
des Türgriffs durchlöchern. Mit den
im Beipack enthaltenen Plastik-
stöpseln die freigebliebenen Löcher
abdecken.
12. Falls erforderlich, Türen ausrichten
Achtung:
Vergewissern Sie sich nach Aus-
führung des Türanschlagwechsels,
daß alle Schrauben fest angezogen
sind und die Türdichtung einwand-
frei am Gehäuse anliegt.
Gegenfalls die Türdichtung vorsichtig mit einem Haartrockner
erwärmen (max.50°C) und von Hand in Form ziehen.
F
D
PR185
F
F
E
F
PR228
G
40
What to do if ...
Correcting Malfunctions
A malfunction may be caused by only a minor fault that you can rectify
yourself using the following instructions. Do not perform any other work on
the appliance if the following information does not provide assistance in
your specific case.
Warning! Repairs to refrigerators/freezers may only be performed by quali-
fied service engineers. Improper repairs can give rise to significant hazards
for the user. If your appliance needs repairing, please contact your speciali-
st dealer or our Customer Service.
Malfunction Possible Cause Remedy
Appliance does not work, no
pilot light is illuminated.
Appliance is not switched on Switch on the appliance.
Mains plug is not plugged in
or is loose.
Insert mains plug.
Fuse has blown or is defective.
Check fuse, replace if neces-
sary.
Socket is defective.
Mains malfunctions are to be
corrected by an electrician.
The freezer temperature is not
sufficient, red light lights up,
temperature signal sounds
The appliance is near a heat
source.
Temperature is not properly
adjusted.
Please look in the "Initial Start
Up" section.
Press the fast freeze switch
Door was open for an exten-
ded period.
Please look in the "Installation
location" section.
Disturbance on the appliance
Switch on the fast freeze swit-
ch, keep the freezer closed,
inform your customer service
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
Open the door only as long as
necessary. Press the fast free-
ze switch
Green light does not light up,
yellow light lights up when
fast freeze fuction is activa-
ted, appliance is on.
Green light faulty.
Please inform your customer
service
Appliance cools too much. Temperature is set too cold.
Turn the temperature regula-
tor to a warmer setting tem-
porarily.
Yellow light does not light up,
when fast freeze fuction is
activated, appliance is on.
Yellow light faulty.
Please inform your customer
service