User Manual

9.4 Door reversibility
To carry out the following opera-
tions, we suggest that this be
made with another person that
will keep a firm hold on the doors
of the appliance during the oper-
ations.
To change the opening direction of the
door, do these steps:
• Remove the plug from the power
socket.
• Tilt back the appliance carefully so
that the compressor cannot touch the
floor.
• Unscrew the left foot.
• Remove the lower door hinge by un-
screwing the 2 retaining screws.
• Remove the hinge pin from the bot-
tom of the door.
• Slot the hinge pin into the hole in the
hinge plate.
• Take the door off.
• Refit the upper hinge pin into the op-
posite location.
• Fit the door in place on the hinge pin.
• Slot the hinge pin into the hole in the
hinge plate and relocate the hinge as-
sembly to the opposite location and
refit using the retaining screws.
• Refit the bottom hinge plate assembly
on the opposite side, taking care that
the edge of the door is parallel with
the side of the cabinet.
1
2
• Remove and install the handle (if fore-
seen)on the opposite side.
• Reposition, level the appliance, wait
for at least four hours and then con-
nect it to the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
ENGLISH 29