User manual

How to replace brush roll or belt
1) Step on handle release to lower handle
flat onto floor (Fig.1).
2) Remove 4 screws from brush roll cover.
(Fig. 2).
3) Lift off brush roll cover. (Fig. 3).
4) Remove brush roll and belt. Thread new
belt around motor shaft and brush roll
(Fig. 4).
5) Insert left end of brush roll first. Make
sure end cap fits into base. Pull right side
of brush roll to stretch belt and insert
right end cap into base (Fig. 5). Make
sure it slides into position.
6) Rotate brush roll 2 turns to center belt.
7) Replace brush roll cover (Fig. 3).
8) Replace 4 screws (Fig. 6).
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig.1
How to maintain your vacuum cleaner
Make sure vacuum cleaner is turned off and power cord is unplugged.
Check belt ZE090. Replace if worn, cut or out of shape.
Avoid touching the motor shaft when checking brush roll or belt.
!
!
Maintain brush roll
Motor pulley can become hot with normal use.
Remove hair and threads from brush roll periodically. Do not remove end caps.
Electrolux Customer Care HELPLINE 08445 614614 Calls to this number will be charged at 5p per minute at all times from a BT Landline. www.electrolux.co.uk
6
Proprietary carpet conditioning and air freshening materials
Proprietary carpet conditioning and air freshening materials
After using proprietary carpet conditioning powders, it is recommended that the filters be changed. Some of these
preparations contain substances which if left in the vacuum for extended periods could damage the plastic
mouldings which form the structure of the vacuum.
Many air fresheners, household deodorants, sprays and polishes contain a highly flammable gas propellant.
Because of this, it is particularly important that these products are used strictly in accordance with the relevant
manufacturer’s instructions.
It is essential that none of the above products are sprayed directly into the vacuum or any of its filters, hose
assembly, dustbag chamber or dustbin.