A52708GNW0 DE Benutzerinformation
www.aeg.com INHALT 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. SICHERHEITSHINWEISE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 GERÄTEBESCHREIBUNG . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 BEDIENFELD . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 TÄGLICHER GEBRAUCH . . . . . . . . . . . . . . . . . . .
DEUTSCH 1. 3 SICHERHEITSHINWEISE Lesen Sie zu Ihrer Sicherheit und für die optimale Geräteanwendung vor der Installation und dem Gebrauch des Gerätes die vorliegende Benutzerinformation aufmerksam durch, einschließlich der Ratschläge und Warnungen. Es ist wichtig, dass zur Vermeidung von Fehlern und Unfällen alle Personen, die das Gerät benutzen, mit der Bedienung und den Sicherheitsvorschriften vertraut sind.
www.aeg.com WARNUNG! Elektrische Bauteile (Netzkabel, Stecker, Kompressor) dürfen zur Vermeidung von Gefahren nur vom Kundendienst oder einer Fachkraft ausgewechselt werden. 1. • • • • Das Netzkabel darf nicht verlängert werden. 2. Vergewissern Sie sich, dass der Netzstecker nicht von der Geräterückseite geklemmt oder beschädigt wird. Ein geklemmter oder beschädigter Netzstecker überhitzt und kann einen Brand verursachen. 3. Vergewissern Sie sich, dass der Netzstecker des Geräts frei zugänglich ist.
DEUTSCH • Ausreichenden Freiraum zur Luftzirkulation um das Gerät lassen; anderenfalls besteht Überhitzungsgefahr. Halten Sie sich für die Belüftung an die Installationsanweisungen. • Das Gerät sollte zur Vermeidung von Verbrennungen durch Berührung von heißen Bauteilen (Kompressor, Kondensator) möglichst mit der Rückseite gegen eine Wand aufgestellt werden. • Das Gerät darf nicht in der Nähe von Heizkörpern oder Kochern installiert werden.
www.aeg.com 2. GERÄTEBESCHREIBUNG 1 2 3 4 6 5 1 Bedienfeld 4 Gefrierkörbe 2 Kältemodul 5 Typenschild 3 Klappe 6 Maxibox Körbe 3. BEDIENFELD 1 2 1 Alarmleuchte 2 Superfrost-Anzeige 3 Superfrost-Taste (Schnellgefrieren) 4 Kontrolllampe 5 Temperaturregler 3 4 5 3.1 Einschalten Stecken Sie den Stecker in die Netzsteckdose. Drehen Sie den Temperaturregler im Uhrzeigersinn auf eine mittlere Einstellung.
DEUTSCH Die Kontrolllampe und die Alarmleuchte leuchten auf. 3.2 Ausschalten des Geräts Drehen Sie den Temperaturregler zum Ausschalten des Geräts in die Position „0“. 3.3 Temperaturregelung Die Temperatur wird automatisch geregelt. Bedienen Sie das Gerät wie folgt: • Drehen Sie den Temperaturregler auf eine niedrigere Einstellung, um die minimal mögliche Kühlung zu erreichen. • Drehen Sie den Temperaturregler auf eine höhere Einstellung, um die maximal mögliche Kühlung zu erreichen.
www.aeg.com Kam es zum Beispiel durch einen Stromausfall, der länger dauerte als der in der Tabelle mit den technischen Daten angegebene Wert (siehe „Lagerzeit bei Störung“) zu einem ungewollten Abtauen, dann müssen die aufgetauten Lebensmittel sehr rasch verbraucht oder sofort gekocht und nach dem Abkühlen erneut eingefroren werden. 4.
DEUTSCH 9 4.4 Entnehmen der Gefrierkörbe und Glasablagen aus dem Gefrierschrank 2 1 Die Ablagen des Geräts sind mit Anschlägen ausgestattet, die zu ihrer Sicherung dienen. Heben Sie die Ablagen auf jeder Seite an (1) und ziehen Sie sie heraus (2). Die mit Expanderrollen ausgestatteten Glasablagen sind durch Haltestifte gesichert. 1 1 2 Um diese zu entfernen, gehen Sie wie folgt vor: 1. Benutzen Sie einen Schraubendreher, um die Haltestifte an jeder Seite der Expanderrollen zu lösen. 2.
www.aeg.com 5. PRAKTISCHE TIPPS UND HINWEISE 5.1 Normale Betriebsgeräusche • Unter Umständen ist ein leichtes Gurgeln und Blubbern zu hören, wenn das Kältemittel durch die Leitungen gepumpt wird. Das ist normal. • Bei eingeschaltetem Kompressor wird das Kältemittel umgewälzt und Sie hören ein Surren und ein pulsierendes Geräusch vom Kompressor. Das ist normal. • Die thermische Ausdehnung kann ein plötzliches Krachen verursachen. Das ist eine natürliche und nicht gefährliche physikalische Erscheinung.
DEUTSCH 11 • Das Haltbarkeitsdatum auf der Tiefkühlkostverpackung darf nicht überschritten werden. 6. REINIGUNG UND PFLEGE 6.1 Reinigung des Innenraums Bevor Sie das Gerät in Betrieb nehmen, beseitigen Sie den typischen „Neugeruch“ am besten durch Reinigen der Innenteile mit lauwarmem Wasser und einer neutralen Seife. Sorgfältig nachtrocknen. Verwenden Sie keine aggressiven Reinigungsmittel oder Scheuerpulver, die die Oberfläche beschädigen.
www.aeg.com 7. FEHLERSUCHE WARNUNG! Ziehen Sie vor der Fehlersuche immer den Netzstecker aus der Steckdose. Die Fehlersuche, die in der vorliegenden Benutzerinformation nicht beschrieben ist, darf nur von einem qualifizierten Elektriker oder einer kompetenten Person durchgeführt werden. Problem Mögliche Ursache Abhilfe Das Gerät funktioniert nicht. Die Kontrolllampe blinkt nicht. Das Gerät ist ausgeschaltet. Gerät einschalten. Der Netzstecker wurde nicht richtig in die Steckdose gesteckt.
DEUTSCH Problem Die Temperatur im Gefrierraum ist zu hoch. Es bildet sich zu viel Eis. Mögliche Ursache Abhilfe Die Fast Freeze -Funktion ist eingeschaltet. Siehe hierzu „Fast Freeze Funktion“. Der Temperaturregler ist nicht richtig eingestellt. Stellen Sie eine niedrigere Temperatur ein. Es wurden zu viele Produkte auf einmal eingelegt. Legen Sie weniger Produkte auf einmal ein. Die Lebensmittel liegen zu dicht aneinander.
www.aeg.com 8.2 Aufstellort 100 mm min Das Gerät sollte in ausreichendem Abstand von Wärmequellen wie Heizungen, Boilern, direkter Sonneneinstrahlung etc. aufgestellt werden. Vergewissern Sie sich, dass Luft an der Rückseite des Gehäuses frei zirkulieren kann. Um einwandfreien Betrieb sicherzustellen, sollte der Abstand zwischen der Oberseite des Gehäuses und dem Hängeschrank mindestens 100 mm betragen, wenn das Gerät unter einem Hängeschrank aufgestellt wurde.
DEUTSCH 15 8.5 Ausrichten Durch eine genaue waagrechte Ausrichtung lassen sich Vibrationen und Geräusche während des Betriebs minimieren. Lösen oder ziehen Sie zum Ausrichten des Geräts die beiden vorderen Schraubfüße an. 8.6 Wechseln des Türanschlags Die nachfolgend beschriebenen Schritte sollten von mindestens zwei Personen durchgeführt werden, um ein Herunterfallen der Türen zu vermeiden.
www.aeg.com 5 4 180° • Schrauben Sie den oberen Bolzen (4) ab und an der gegenüberliegenden Seite an. (5) • Bringen Sie die Tür wieder an. • Bringen Sie die beiden unteren Scharniere an und ziehen Sie sie fest. • Setzen Sie die Sockelblende (8) wieder ein. • Bringen Sie den Griff auf der gegenüberliegenden Seite an und setzen Sie die Kunststoffkappen (im Beutel mit der Anleitung) auf die freien Öffnungen.
DEUTSCH CLICK! BRRR! BLUBB! HISSS! CLICK! BRRR! BLUBB! HISSS! 17
www.aeg.com SSSRRR! SSSRRR! CRACK! CRACK! 10. TECHNISCHE DATEN Abmessungen Höhe 1850 mm Breite 595 mm Tiefe 658 mm Lagerzeit bei Störung 28 Std. Spannung 230-240 V Frequenz Die technischen Daten befinden sich auf dem Typenschild im Innern des Gerätes 50 Hz auf der linken Seite sowie auf der Energieplakette. 11. UMWELTTIPPS Recyceln Sie Materialien mit dem Symbol . Entsorgen Sie die Verpackung in den entsprechenden Recyclingbehältern.
DEUTSCH Gerät zu Ihrer örtlichen Sammelstelle oder wenden Sie sich an Ihr Gemeindeamt.
280150705-A-202012 www.aeg.