A72900GNW0 A72900GNX0 EN User manual
www.aeg.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 CONTROL PANEL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 DAILY USE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 HELPFUL HINTS AND TIPS . . . . . . . . . . . . . . .
ENGLISH 1. 3 SAFETY INSTRUCTIONS In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features.
www.aeg.com WARNING! Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personnel to avoid hazard. 1. • • • • Power cord must not be lengthened. 2. Make sure that the power plug is not squashed or damaged by the back of the appliance. A squashed or damaged power plug may overheat and cause a fire. 3. Make sure that you can come to the mains plug of the appliance. 4. Do not pull the mains cable. 5.
ENGLISH • The appliance must not be located close to radiators or cookers. • Make sure that the mains plug is accessible after the installation of the appliance. • Connect to potable water supply only (If a water connection is foreseen). ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish.
www.aeg.com 1. Connect the mains plug to the power socket. 2. Press the ON/OFF button if the display is off. 3. The alarm buzzer could operate after few seconds. To reset the alarm refer to “High temperature alarm”. 4. If "dEMo" appears on the display, the appliance is in demonstration mode. Refer to "What to do if..." paragraph. 5. The temperature indicators show the set default temperature. To select a different set temperature refer to "Temperature regulation".
ENGLISH 3. The Minute Minder indicator goes off. It is possible to change the time during the countdown and at the end by pressing the Temperature colder button and the Temperature warmer button. 2.7 Child Lock function To lock the buttons from unintentional operation select the Child Lock function. To switch on the function: 1. Press the Mode button until the corresponding icon appears. 2. The Child Lock indicator flashes. 3. Press the OK button to confirm. The Child Lock indicator is shown.
www.aeg.com In the event of accidental defrosting, for example due to a power failure, if the power has been off for longer that the value shown in the technical characteristics chart under "rising time", the defrosted food must be consumed quickly or cooked immediately and then re-frozen (after cooling). tor compartment or at room temperature, depending on the time available for this operation.
ENGLISH 9 3.5 Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. Check that the drain hose at the rear of the cabinet discharges into the drip tray 4. HELPFUL HINTS AND TIPS 4.
www.aeg.com 5. CARE AND CLEANING CAUTION! Unplug the appliance before carrying out any maintenance operation. damage the plastics used in this appliance. For this reason use a soft cloth rinsed in warm water and neutral soap emulsion for cleaning external surfaces. This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians.
ENGLISH 11 5.4 Cleaning the ventilation grille The ventilation grille can be removed for washing. Make sure the door is open and then: • Loosen the upper edge of the grille by pulling outward/downward. • Pull the grille straight out to completely remove it. • Vacuum clean under the cabinet. 6. WHAT TO DO IF… During operation of the appliance some smaller but annoying trouble can often occur, which does not require calling a technician out.
www.aeg.com Problem Possible cause Solution The compressor runs The Temperature regula- Set a warmer temperature. continuously. tor may be set incorrectly. There is too much frost and ice. The door is not closed correctly. Refer to "Closing the door". The door has been opened too frequently. Do not keep the door open longer than necessary. The food temperature is too high. Let the food temperature decrease to room temperature before storage. The room temperature is too high.
ENGLISH Problem Possible cause Solution The door has been open to long. Close the door. Door interferes with ventilation grill. The appliance is not levelled. Refer to "Levelling". Misaligned door. The appliance is not levelled. Refer to "Levelling". 13 As much as the advice does not lead to result, call the nearest brand-mark service. 6.1 Replacing the lamp The appliance is equipped with a longlife LED light. Only service is allowed to replace the lighting device. Contact your Service Center.
www.aeg.com 7.3 Location To ensure best performance, if the appliance is positioned below an overhanging wall unit, the minimum distance between the top of the cabinet and the wall unit must be at least 40 mm . Ideally, however, the appliance should not be positioned below overhanging wall units. The ventilation space can be: • directly above the appliance • behind and above the top cupboard. In this case, the space behind the top cupboard must be at least 50 mm deep. 50 mm 7.
ENGLISH 15 7.6 Levelling When placing the appliance ensure that it stands level. If necessary adjust the feet using the adjustment spanner supplied. Door alignment is dependent on proper levelling. 7.7 Door reversibility 1 2 1 2 3 4 To change the opening direction of the door, do these steps: • Remove the plug from the power. • Remove the ventilation grille. Remove the upper filling and install it on the opposite side of the grille.
www.aeg.com 3 1 2 • Unscrew the lower hinge (1). Move the pin to the opposite side (2). • Unscrew and move the pedal to the opposite side (3). • Screw on the lower hinge on the opposite side. • Tighten the pin with the adjustment spanner supplied. • Use a small screw driver to remove the bushing on the top of the door and move it to the opposite side on the door. • Install the handle on the opposite side. • Raise the appliance and install the ventilation grille. • Put the cabinet in position.
ENGLISH SSSRRR! HISSS! BLUBB! SSSRRR! HISSS! BLUBB! CLICK! BRRR! CRACK! 17 CLICK! BRRR! CRACK!
www.aeg.com 9. TECHNICAL DATA A72900GNW0 A72900GNX0 Height 1800 mm 1800 mm Width 595 mm 595 mm Depth 623 mm 623 mm Rising Time 12 h 12 h Voltage 230 V 230 V Frequency 50 Hz 50 Hz Dimension The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. 10. ENVIRONMENT CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it.
ENGLISH 19
298376914-D-452012 www.aeg.
