User manual

Take care of not to damage the
cooling system.
When moving the cabinet, lift it
by the front edge to avoid
scratching the floor.
Many proprietary kitchen surface clean-
ers contain chemicals that can attack/
damage the plastics used in this appli-
ance. For this reason use a soft cloth
rinsed in warm water and neutral soap
emulsion for cleaning external surfaces.
Do not use detergents or abra-
sive paste as these will damage
the paint, or stainless steel anti
finger print coating.
After cleaning, reconnect the equipment
to the mains supply.
5.2 Defrosting of the freezer
The freezer compartment of this model,
on the other hand, is a "no frost" type.
This means that there is no buildup of
frost when it is in operation, neither on
the internal walls nor on the foods.
The absence of frost is due to the con-
tinuous circulation of cold air inside the
compartment, driven by an automatically
controlled fan.
5.3 Periods of non-operation
When the appliance is not in use for
long periods, take the following precau-
tions:
1.
disconnect the appliance from elec-
tricity supply
2.
remove all food
3.
clean the appliance and all accesso-
ries
4.
leave the door/doors open to pre-
vent unpleasant smells.
If the cabinet will be kept on, ask
somebody to check it once in a
while to prevent the food inside
from spoiling in case of a power
failure.
5.4 Cleaning the ventilation grille
The ventilation grille can be removed for
washing.
Make sure the door is open and then:
• Loosen the upper edge of the grille by
pulling outward/downward.
• Pull the grille straight out to complete-
ly remove it.
• Vacuum clean under the cabinet.
6. WHAT TO DO IF…
During operation of the appliance some
smaller but annoying trouble can often
occur, which does not require calling a
technician out. In the following chart in-
formation is given about them to avoid
unnecessary charges on service.
The operation of the appliance
goes with certain sounds (com-
pressor and circulating sound).
This not means a trouble, but a
normal operation.
The appliance operates discon-
tinuously, so the stopping of
compressor does not mean be-
ing no current. That is why you
must not touch the electrical
parts of the appliance before
breaking the circuit.
ENGLISH 11