User manual

10.5 Door reversibility
2
1
3
4
To carry out the following opera-
tions, we suggest that this be
made with another person that
will keep a firm hold on the doors
of the appliance during the oper-
ations.
To change the opening direction of the
door, do these steps:
• Remove the plug from the power
socket.
• Tilt back the appliance carefully so
that the compressor cannot touch the
floor.
• Unscrew both adjustable feet.
• Unscrew the screws of the door bot-
tom hinge.
• Take off the appliance door by pulling
it slightly downwards.
2
1
• Unscrew the top door hinge pin of the
appliance then screw it back on the
other side
• Fit the appliance door on the upper
door hinge pin.
• Remove the lower hinge. Put over the
pin in the direction of the arrow.
• Unscrew and install the screw on the
opposite side.
• Install the lower hinge on the opposite
side leaving the position of the door
unchanged.
• Screw in the one screw in the place set
free on the other side as well as the
adjustable feet (2 pieces).
1
2
3
4
Remove and install the handle (if fore-
seen) on the opposite side
Reposition, level the appliance, wait for
at least four hours and then connect it to
the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
68
www.aeg.com