Operation Manual

Problem Possible cause Solution
The door is not closed
correctly.
Refer to "Closing the
door".
The product temperature
is too high.
Let the product tempera-
ture decrease to room
temperature before stor-
age.
Many products are stored
at the same time.
Store less products at the
same time.
Products are too near to
each other.
Store products so that
there is cold air circulation.
Upper or lower
square is shown in
the temperature dis-
play.
An error has occurred in
measuring the tempera-
ture.
Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not
be possible).
dEMo appears on
the Display.
The appliance is in dem-
onstration mode (dEMo).
Keep pressed approxi-
mately 10 sec. the OK but-
ton since a long sound of
buzzer is heard and the
Display shut off for a short
while: appliance start
works regularly.
6.1 Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer
to "Installation".
3.
If necessary, replace the defective
door gaskets. Contact the Service
Center.
7. INSTALLATION
7.1 Positioning
WARNING!
If you are discarding an old appli-
ance that has a lock or catch on
the door, you must ensure that it
is made unusable to prevent
young children being trapped in-
side.
The appliance shall have the
plug accessible after installation.
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Cli-
mate
class
Ambient temperature
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
7.2 Electrical connection
Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic pow-
er supply.
26
www.aeg.com