User manual

Problem Possible cause Solution
Food products placed in
the appliance were too
warm.
Allow food products to cool to
room temperature before stor-
ing.
The "FROSTMATIC or
"COOLMATIC is switched
on.
Refer to "FROSTMATIC func-
tion" or "COOLMATIC func-
tion".
The compressor does not
start immediately after
pressing the "FROSTMATIC
or "COOLMATIC, or after
changing the temperature.
This is normal, no error has
occurred.
The compressor starts after a
period of time.
Water flows inside the refrig-
erator.
Food products prevent the
water to flow into the wa-
ter collector.
Make sure that food products
do not touch the rear plate.
Water flows on the floor. The melting water outlet is
not connected to the
evaporative tray above the
compressor.
Attach the melting water out-
let to the evaporative tray.
Temperature cannot be set. The "FROSTMATIC func-
tion" or "COOLMATIC
function" is switched on.
Switch off "FROSTMATIC
function" or "COOLMATIC
function" manually, or wait un-
til the function resets automat-
ically to set the temperature.
Refer to "FROSTMATIC func-
tion" or "COOLMATIC func-
tion".
dEMo appears on the dis-
play.
The appliance is in demon-
stration mode.
Keep the OK pressed for ap-
proximately 10 seconds until a
long sound is heard and dis-
play shuts off for a short time.
The temperature in the ap-
pliance is too low/too high.
The temperature regulator
is not set correctly.
Set a higher/lower tempera-
ture.
The door is not closed cor-
rectly.
Refer to "Closing the door".
The food products' tem-
perature is too high.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Many food products are
stored at the same time.
Store less food products at the
same time.
The door has been
opened often.
Open the door only if necessa-
ry.
www.aeg.com16