Instruction manual

27
ENGLISH
CAUTION:
When disposing of old batteries you should strictly
comply with the legal and environmental regulations
applicable in your country. Do not throw batteries into
re!
NOTE:
• Thelithiumcellinthebatterycompartmentofthe
remote control has been secured for transport with a
foil.
Before initial use please remove
this foil so that the remote
control is ready for operation.
• Thelifetimeoftheenclosed
battery may be shortened
because of storage.
The battery of the remote control is a long-life lithium
cell. If the range of the remote control is reduced during
use, please proceed as follows:
• Openthebatterycompartmentonthebackofthe
remote control.
• Replacethecellbyabatteryofthesametype
(CR 2025). Ensure correct polarity.
• Thenclosethebatterylid.
If the remote control is not used for a prolonged period,
remove the batteries in order to prevent battery acid
leaking.
WARNING:
Do not expose the batteries to high temperatures or
direct sunlight. Never throw batteries into the re. There
is a danger of explosion!
CAUTION:
Batteries are not to be disposed of together with
domestic wastes. Dispose of the used batteries at the
relevant collection bin or at your dealer’s.
NOTE:
The signals from the remote control are transmitted to
the device by infrared light. You should therefore ensure
that the device is not in direct sunlight. This might make
transmission of the signals from the remote control to
the device impossible.
Eective range of the remote control
Point the remote control at the remote control sensor on
the right next to the display on the front of the device.
The distance between remote control and sensor should
not exceed 5 m. The angle of the remote control to the re-
mote control sensor to right, left, top and bottom should
not exceed 30°.
Operation (Illustration 2: Control Panel)
NOTE:
Some keys are to be found both on the device itself
and on the remote control. Keys with the same desig-
nation have the same function.
1
Button
Press the - button to release and detach the front
control panel.
2 On/O Button
Press this button to switch the device on. Keep this
buttonpressedtoswitchthedeviceo.
MUT
Switchesothevolumequickly.“MUTE”appearson
the display. To cancel this function, press the MUT
button again.
3 BND/AMS Button
a) Radio Operation
Press once shortly:
Briey press the BND/AMS button to switch
between FM (FM) and AM (medium wave) bands.
The designation of the corresponding level FM 1,
FM2, FM3, AM1, AM2 appears in the LCD display.
Press and hold down:
Hold down the BND/AMS button to start the
automatic station search. The stations are stored
in ascending order of frequency.
b) CD/MP3/DVD mode
Switch between the colour systems PAL, NTSC
and AUTO.