User manual

76
Door Alignment
If necessary, the appliance door can be aligned.
0 First remove the door (see section: "Re-Hanging Door").
0 Using a small screw-driver, lift out the eccentric bearing bushes as
required, above the appliance or below the door, rotate and then press
in according to the figures.
The diagram only shows a right opening door.
For left opening doors please proceed accordingly at the left of the
door at top and/or bottom.
0 Replace the door (see section: "Re-Hanging Door")
Electrical Connection
A properly installed socket outlet with earthing contact is required for
electrical connection. Electrical fuse protection must be of at least 10
ampere.
If the outlet socket is no longer accessible after installation of the
appliance, appropriate measures must be taken during electrical
installation to assure that the appliance can be disconnected from the
mains (e.g. fuse, circuit breaker, non-operate current safety-switch or
the like, with a contact opening of at least 3 mm).