You have purchased a freezer for'your home which has been produced in compliance with the. standards applicable to these appliances. In manufacture measures have been taken as required in particular by the West German Appliance Safety Law, the Accident Prevention Regulations for refrigerating equipment and the requirements of the Association of German Electrical Engineers. The refrigerating circuit has been checked for enrage. This appliance contorts to E.EC. directive Nr. 76/883/EEC on radio interference.
Earthing contact socket The earthing contact socket outset necessary for connecting the freezer to the electricity supply should b fitted in accordance with Figure B. Mounting in furniture surround The rear of the furniture housing may eve been fitted with a stiffening panel for transport purposes. This must be removed prior to installation. For combination fridge-freezer appliances the she! between the refrigerator and freezer must be constructed in accordance with Figures €, C 1 for ventilation purposes.
J making allowance for dimension Now take off the appliance door by lifting it out and secure the slide with additional screws. For frame doors with resilient packing the pruners must be affixed to the appliance sours at the holes provided on the upper and lower edges. The expos ext holes are (o be fitted with Blanking screws in order to prevent the entry of moisture. The slide on the furniture doorstop fitted as described above. Attention! The slide should be inclined. slightly towards the door.
the thermometer which is integrated in the middle compartment flap. Adjust the temperature regulator so that the temperature shown is ~18°C. This Is achieved under normal operating conditions by middies regulation setting. You can also set the control to a warmer setting {position you wish to store food or only a short period. Freezing fresh food You can freeze fresh rood yourself.
meals. This would result in heavy frost formation on the evaporators: and an increase in power consumption Preparing ice The ice tray can be used for preparing ice ¢ '»am or ice cubes in the per-ireezing compartment, Never use sharp or pointed implements 1o free the ice tray if the natter has frozen to the flair of the compartment.
(&8> Allure and servicing Before approaching our Service Canter check whether the indicator tamps will fight up and whether the refrigeration system is operating and the internal temperature is stilt being maintained i the refrigerating shyster is operating but the green lamp does not light up, turn the control knob 10 «S». If the amber lamp lights up. the green lamp must be defective and the Service Center should be notified. Should neither of the lamps light up. check that power is available.
14. Unscrew the upper stopper and remove. 18, Push stopper into apposite side and secure with screws. 16. Remove plastic rivet trim eccentric bush and insert in opposite bush. 17. (insert upper door pivot in eccentric bush. 18. Place door on lower pivot 19. Lean door on the housing above and push pivot into housing slog. 20. At fix door pivot with 2 screws. 1f necessary the door can be aligned by altering the eccentric pivot bushes (after taking off the door} and can be completely sealed.