Operation Manual

14 www.aeg.com
7.
OPERATING INSTRUCTIONS
Some of the following instructions
can only be used by using the
Control Panel.
It is not necessary to use the
drainage hose in the “cool” mode.
Cooling mode
Heating mode (on some models)
In this mode the exhaust adaptor hose
MUST be used.
In this mode the exhaust adaptor hose
MUST be used.
7.1 Usage of the Control Panel
1.
Press the “mode” button until the
Cool mode indicator is lit.
2.
Press the “fan speed” button to
choose the fan speed according
to the illumination of the fan speed
indicator. You can choose the
fan speed as following sequence:
“auto” → “hi” → “med” → “low” → “auto”.
3.
Press the “ ” or “ ” button to choose
the temperature you want.
1.
”taeH“ eht litnu nottub ”edom“ eht sserP
indicator is lit.
2.
Press the “fan speed” button to
choose the fan speed according
to the illumination of the fan speed
indicator. You can choose the
fan speed as following sequence:
“auto” → “hi” → “med” → “low” → “auto”.
3.
Press the “ ” or “ ” button to choose
the temperature you want.
4.
Connected drain hose. See 7.4
Drainage section.
6.
AIR CONDITIONER FEATURES
6.1 CONTROL PANEL
Displays temperature/time
1
Power ON/OFF
2
Sleep
7
Filter Reset
3
Fan Speed
4
Adjust Temperature or Timer
5
Mode Selection
6
Timer
8
Swing
9
Dry mode
Press the “mode” button until the Dry
mode indicator is lit. The screen displays
the room temperature.
At the same time, the “low” fan indicator
lights.
Note:
In this mode, fan speed cannot be
selected.
Fan mode
In this mode, there is no need to use the
exhaust hose or drainage hose.
1.
Press the “mode” button until the Fan
mode indicator is lit.