Oven User Manual
30
Preparing the oven cavity
We recommend mounting ovens on plinths (see previous page) and flush mounting installation
(refer securing the oven below).
WARNING:
It is important to the performance of the oven and the protection of adjoining cabinets that
the following installation preparation is observed.
11. The oven cavity floor should provide plinths to left and right side
approximately 4” wide with the maximum clear opening to base under oven.
Allowing a satisfactory free area through the middle to assist with air
circulation around the appliance.
12. The rear wall of the oven cavity should not have a back attached – it should be
clear to allow for improved air circulation around the appliance. A space of at
least 4” (but more if possible) to any rear wall is recommended.
The above steps will greatly reduce the outer oven surface temperatures making the
kitchen environment safer. It will also protect both the appliance and the adjoining
cabinets.
Securing the oven
Once correctly wired into (while electrically isolated from) the main power, locate the oven into the
recess and ensure the appliance is parallel to the front fascia of the enclosure, use packing under
the appliance if necessary. Four screws are supplied to secure the oven to the cupboard cavity.
The fixing holes are in the oven trim surrounds (visible when you open the oven door/s). Slide the
oven fully into the recess and insert the four screws through the mounting holes and into the
cupboard surround to secure the oven position. We recommend a flush to cupboard face
installation. The measurement of the front trim of the oven (20mm) is designed to equal normal
cupboard facing material after allowing for the body of the oven to be secured against the
cupboard carcass.