User manual

Everyday Use
Clean the oven cavity after each use. Fat accumulation or other food re-
mains may cause fire. The risk is higher for the grill pan.
Dry the cavity with a soft cloth after each use.
Accessories
Clean all accessories after each use and let them dry. Use a soft cloth with
warm water and a cleaning agent. Do not clean the accessories in a dish-
washer.
Do not clean the non-stick accessories using aggressive agents, sharp-
edged objects or in a dishwasher.
11.2 Removing the shelf
supports
To clean the oven, remove the shelf
supports.
CAUTION!
Be careful when you remove
the shelf supports.
1. Pull the front of the shelf support
away from the side wall.
2. Pull the rear end of the shelf support
away from the side wall and remove
it.
2
1
Install the removed accessories in the
opposite sequence.
The retaining pins on the
telescopic runners must
point to the front.
11.3 Catalytic cleaning
The cavity with a catalytic coating is self-
cleaning. It absorbs fat.
Before you turn on the catalytic cleaning:
• remove all the accessories and
removable shelf supports.
• clean the oven floor with warm water
and mild detergent.
• clean the inner door glass with warm
water and soft cloth.
1. Set the function .
You cannot change the duration of the
Catalytic cleaning. You can delay the
start of the cleaning with the function:
END.
The signal sounds at the end of cleaning.
2. Press any button to stop the signal.
3. Turn off the oven.
To stop the cleaning before it finishes
turn the knob for the heating functions to
the off position.
4. When the oven cools down, clean
the cavity with a wet soft cloth.
Spots or discolouration of the catalytic
coating have no effect on Catalytic
cleaning.
11.4 Cleaning reminder
As a reminder that catalytic cleaning is
necessary, CATA flashes in the display
for 10 seconds after each activation and
deactivation of the oven.
The cleaning reminder goes out:
• after the end of the Catalysis function.
www.aeg.com
34