User manual

Problem Possible cause Remedy
The display shows an error
code that is not in this table.
There is an electrical fault. • Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows the
error code again, contact
the Customer Care De-
partment.
There is no good cooking
performance using the True
Fan Cooking PLUS function.
You did not activate the
True Fan Cooking PLUS
function.
Refer to "Activating the True
Fan Cooking PLUS func-
tion".
There is no good cooking
performance using the True
Fan Cooking PLUS function.
You did not fill the cavity
embossment with water.
Refer to "Activating the True
Fan Cooking PLUS func-
tion".
The water in the cavity em-
bossment does not boil.
The temperature is too low. Set the temperature at least
to 110 °C.
Refer to “Hints and tips”
chapter.
The water comes out of the
cavity embossment.
There is too much water in
the cavity embossment.
Deactivate the oven and
make sure that the appliance
is cold. Wipe the water with
a cloth or sponge. Add the
correct amount of water to
the cavity embossment. Re-
fer to the specific procedure.
The appliance is activated
and does not heat up. The
fan does not operate. The
display shows "Demo".
The demo mode is activa-
ted.
1. Deactivate the oven.
2. Press and hold the but-
ton .
3. The first digit on the dis-
play and Demo indicator
start to blink.
4. Enter the code 2468 by
pressing the buttons
or to change the val-
ues and press to con-
firm.
5. The next digit starts to
blink.
6. Demo mode deactivates
when you confirm the
last digit and the code is
correct.
ENGLISH
35