User manual

1
2
7.
Carefully lift (step 1) and remove
(step 2) the glass panels one by one.
Start from the top panel.
8.
Clean the glass panels with water
and soap. Dry the glass panels care-
fully.
Installing the door and the glass panel
When the cleaning is completed, install
the glass panels and the oven door. Do
the above steps in the opposite se-
quence.
Make sure that you put the glass panels
back in the correct sequence. The mid-
dle panel has a decorative frame. The
screen-printing zone must face the inner
side of the door. Make sure that after the
installation the surface of the glass panel
frame on the screen-printing zones is not
rough when you touch it.
Make sure that you install the middle
panel of glass in the seats correctly (refer
to the illustration).
11. WHAT TO DO IF…
WARNING!
Refer to the Safety chapters.
Problem Possible cause Remedy
The oven does not heat
up.
The appliance is deacti-
vated.
Activate the appliance.
The oven does not heat
up.
The clock is not set. Set the clock.
The oven does not heat
up.
The necessary settings
are not set.
Make sure that the set-
tings are correct.
The oven does not heat
up.
The fuse in the fuse box
is released.
Do a check of the fuse. If
the fuse is released more
than one time, contact a
qualified electrician.
The oven lamp does not
operate.
The oven lamp is defec-
tive.
Replace the oven lamp.
ENGLISH 21