User manual

2. Lift and turn the levers on the two
hinges.
3. Close the oven door halfway to the
first opening position. Then pull
forward and remove the door from its
seat.
4. Put the door on a soft cloth on a
stable surface.
5.
Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the clip
seal.
1
2
B
6. Pull the door trim to the front to
remove it.
7. Hold the door glass panels by their
top edge and carefully pull them out
one by one. Start from the top panel.
Make sure the glass slides out of the
supports completely.
8. Clean the glass panels with water
and soap. Dry the glass panels
carefully.
When the cleaning is completed, install
the glass panels and the oven door. Do
the above steps in the opposite
sequence.
Make sure that you put the glass panels
(A and B) back in the correct sequence.
The first panel (A) has a decorative
frame. The screen-printing zone must
face the inner side of the door. Make
sure that after the installation the surface
of the glass panel frame (A) on the
screen-printing zones is not rough when
you touch it.
ENGLISH
19