Operating Instructions and Installation Instructions

14
Installation - for contractors
26_07_80_0054
Note
Note the alignment of the wall sleeves.
» Use screws to secure the wall sleeves.
» Secure the retainers to the rungs. Do not yet tighten
the retainers.
26_07_80_0056
» Fit the wall mounting bracket. For this, observe the
slot position. The slot must point respectively up or
down.
D0000040882
» Assemble the appliance and wall mounting bracket.
» Insert and tighten the screws to secure the
appliance.
9.3 Fitting the bathrobe hooks
26_07_80_0055
1 32
1 Bathrobe hook
2 Washer
3 Bathrobe hook backplate
» Fit the bathrobe hooks as shown.
10. Power supply
WARNING Electrocution
In wet rooms such as shower rooms and kitchens,
install the ush box at least 25 cm above the oor.
WARNING Electrocution
Never operate the appliance with an extension cable
or a multiple socket.
!
Material losses
Ensure the appliance can be separated from the
power supply by an isolator that disconnects all
poles with at least 3 mm contact separation. For this,
use contactors, mains isolators, fuses, etc. Installa-
tion with a permanent power cable is not permitted.
!
Material losses
Observe the type plate. The specied voltage must
match the mains voltage.
Note
Carry out all electrical connection and installation
work in accordance with national and regional reg-
ulations.
Note
Ensure a standard socket or junction box for a per-
manent power supply is installed at a distance of at
least 10 cm from the side of the appliance.
11. Troubleshooting
The power cable must only be replaced by a qualied
contractor using original spare parts.
12. Appliance handover
» Explain the functions of the appliance to the user.
» Draw special attention to the safety instructions.
» Pass on the operating and installation instructions to
the user.