Operation Manual

English
88
b. Then the current memory bank (U1, U2, or U3) is displayed. See Fig. 6-1. Press the
“MEM” button to change to the other bank. Confirm your selection by pressing
the “START” button. The current bank will also be confirmed automatically after
5 seconds with no operation.
Fig. 6
Fig. 6-1
c. When the current memory bank has stored results, the display momentarily
displays the newest one. If no result was stored, a zero appears in the display.
See Fig. 6-2 & 6-3.
d. The monitor inflates the cuff until sufficient pressure has built up for a measure-
ment. Then the monitor slowly releases air from the cuff and carries out the
measurement. Finally the blood pressure and pulse rate will be calculated and
displayed on the LCD screen separately. The blood pressure classification indica-
tion and (possibly) the “arrhythmia” symbol will flash on the display. See Fig. 6-4.
The result will be automatically stored in the current memory bank.
Fig. 6-2 Fig. 6-3 Fig. 6-4
e. After measurement, the monitor will turn off automatically after 1 minute of no
operation. You can also press the “START” button to turn off the monitor manu-
ally.
f. During measurement, you can press the “START” button to turn off the monitor
manually.
Note:
Please consult a health care professional for interpretation of pressure measure-
ments.