BOCSE FR Notice d'utilisation
www.aeg.com SOMMAIRE 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. CONSIGNES DE SÉCURITÉ . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 INSTRUCTIONS DE SÉCURITÉ . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 DESCRIPTION DE L'APPAREIL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 AVANT LA PREMIÈRE UTILISATION . . . . . . . . . . . . . . . .
FRANÇAIS 3 1. CONSIGNES DE SÉCURITÉ Avant d'installer et d'utiliser cet appareil, lisez soigneusement les instructions fournies. Le fabricant ne peut être tenu pour responsable des dommages et blessures liés à une mauvaise installation ou utilisation. Conservez toujours cette notice avec votre appareil pour vous y référer ultérieurement. 1.1 Sécurité des enfants et des personnes vulnérables AVERTISSEMENT Risque d'asphyxie, de blessure ou d'invalidité permanente.
www.aeg.com • • • • 2. gants de cuisine pour retirer ou enfourner des accessoires ou des plats allant au four. N’utilisez pas de nettoyeur vapeur pour nettoyer l'appareil. Avant toute opération de maintenance, déconnectez l'alimentation électrique. N'utilisez pas de produits abrasifs ni de racloirs pointus en métal pour nettoyer la porte en verre car ils peuvent rayer sa surface, ce qui peut briser le verre.
FRANÇAIS • • • • • • porte de l'appareil, particulièrement lorsque la porte est chaude. La protection contre les chocs des parties sous tension et isolées doit être fixée de telle manière qu'elle ne peut pas être enlevée sans outils. Ne branchez la fiche d'alimentation à la prise de courant qu'à la fin de l'installation. Assurez-vous que la prise de courant est accessible une fois l'appareil installé. Si la prise de courant est lâche, ne branchez pas la fiche d'alimentation secteur.
www.aeg.com Cuisson à la vapeur AVERTISSEMENT Risque de brûlures et de dommages matériels à l'appareil. • Au cours de la cuisson à la vapeur, n'ouvrez pas la porte. De la vapeur pourrait s'échapper. 2.3 Entretien et nettoyage AVERTISSEMENT Risque de blessure corporelle, d'incendie ou de dommage matériel à l'appareil. • Avant toute opération d'entretien, mettez à l'arrêt l'appareil et débranchez la fiche de la prise secteur. • Vérifiez que l'appareil est froid.
FRANÇAIS 7 3. DESCRIPTION DE L'APPAREIL 1 2 1 Bandeau de commande 3 2 Programmateur électronique 3 Bac à eau 4 Éclairage 3 7 4 2 5 Générateur de vapeur avec cache 6 Support de grille amovible 7 Position des grilles 1 5 6 3.1 Accessoires ATTENTION N'utilisez pas le plateau de cuisson ni le plat à rôtir avec la fonction Vapeur intense. Grille métallique Permet de poser des plats (à rôti, à gratin) et des moules à gâteau/pâtisserie.
www.aeg.com • Nettoyez l'appareil avant de l'utiliser pour la première fois. de courant, vous devez régler la langue, le contraste de l'affichage, sa luminosité ou pour et l'heure. Appuyez sur régler la valeur. Presser OK pour confirmer. Reportez-vous au chapitre « Entretien et nettoyage ». 4.2 Premier branchement Lorsque vous raccordez l'appareil à l'alimentation secteur ou après une coupure 5. BANDEAU DE COMMANDE 5.
FRANÇAIS Touche Numéro sensiti- Fonction ve 9 Commentaire 6 Touche Haut Pour se déplacer vers le haut dans le menu. 7 OK Pour confirmer la sélection ou les réglages. 8 Touche Accueil Pour remonter d'un niveau dans le menu. Pour afficher le menu principal, appuyez sur cette touche pendant 3 secondes. 9 Heure et fonctions supplémentaires Pour régler d'autres fonctions.
www.aeg.com 6. UTILISATION QUOTIDIENNE AVERTISSEMENT Reportez-vous aux chapitres concernant la sécurité. 6.1 Navigation dans les menus 1. 2. Appuyez sur OK pour passer au sous-menu ou accepter le réglage. À tout moment, vous pouvez revenir au 3. menu principal avec la touche . Allumez l'appareil. Appuyez sur ou pour sélectionner l'option de menu. 6.
FRANÇAIS Symbole 11 Sous-menu Description Affichage contraste Ajuste le contraste de l'affichage par paliers. Affichage luminosité Ajuste la luminosité de l'affichage par paliers. Langue Règle la langue de l'affichage. Volume alarme Permet de régler le volume des tonalités des touches et des signaux sonores par paliers. Tonalité touches Active et désactive la tonalité des touches sensitives. Il est impossible de désactiver la tonalité de la touche Marche/Arrêt.
www.aeg.com La vapeur apparaît au bout d'environ 2 minutes. Lorsque l'appareil atteint la température réglée, un signal sonore retentit. Le signal sonore retentit également à la fin de la durée de cuisson. 6. Éteignez l'appareil. Lorsque le générateur de vapeur est vide, un signal sonore retentit. Une fois que l'appareil a refroidi, épongez toute l'eau restant dans le générateur de vapeur. Si nécessaire, nettoyez le générateur de vapeur avec du vinaigre.
FRANÇAIS de 90 % de la durée définie. L'appareil utilise la chaleur résiduelle pour poursuivre la cuisson jusqu'à la fin de la durée définie. La chaleur résiduelle peut durer de 3 à 20 minutes. Réglage des fonctions de l'horloge : Réglez un mode de cuisson. 1. 2. Appuyez sur à plusieurs reprises jusqu'à ce que la fonction de l'horloge souhaitée et le symbole correspondant s'affichent. 3. Appuyez sur la touche ou pour régler la durée nécessaire. Appuyez sur OK pour confirmer.
www.aeg.com 8. PROGRAMMES AUTOMATIQUES AVERTISSEMENT Reportez-vous aux chapitres concernant la sécurité. 8.1 Cuisson assistée avec Recettes automatiques Sélectionnez le menu Cuisson assistée . Presser OK pour confirmer. 3. Sélectionnez la catégorie et le plat. Presser OK pour confirmer. 4. Sélectionnez Recettes automatiques . Presser OK pour confirmer. 2. Si vous utilisez la fonction Cuissons traditionnelles , l'appareil utilise des réglages automatiques.
FRANÇAIS 15 10. FONCTIONS SUPPLÉMENTAIRES 10.1 Menu Programme préféré Vous pouvez sauvegarder vos réglages préférés tels que la durée, la température ou le mode de cuisson. Ils sont disponibles dans le menu Programme préféré . Vous pouvez sauvegarder 20 programmes. 10.2 Touches Verrouil. La fonction Touches Verrouil. permet d'éviter une modification involontaire du mode de cuisson. Vous ne pouvez activer la fonction Touches Verrouil. que lorsque l'appareil est en fonctionnement.
www.aeg.com 5. Appuyez sur à plusieurs reprises jusqu'à ce que l'affichage indique SET + GO . 6. Presser OK pour confirmer. Pour démarrer la fonction SET + GO , appuyez sur une touche sensitive (à l'ex). Le mode de cuisson réception de glé démarre. À la fin du mode de cuisson, un signal sonore retentit. Informations utiles : • La fonction SET + GO peut être activée et désactivée dans le menu Règlages de base . 10.
FRANÇAIS 4. Un signal sonore retentit lorsque le programme est terminé. Appuyez sur une touche sensitive pour arrêter le signal. 5. Essuyez l'appareil avec un chiffon doux. Ôtez l'eau restante du générateur de vapeur. 6. Laissez la porte de l'appareil ouverte pendant environ 1 heure. Attendez le séchage complet de l'appareil. 11.2 Système de génération de vapeur ATTENTION Séchez le générateur de vapeur après chaque utilisation. Épongez l'eau résiduelle.
www.aeg.com 3. Sortez le support de la prise arrière. Remontage du support de grille Pour remonter le support de grille, suivez la même procédure dans l'ordre inverse. 11.4 Porte de l'appareil Enlevez la porte pour nettoyer plus facilement l'intérieur de l'appareil. Retrait de la porte de l'appareil 1. Ouvrez complètement la porte. 2. Libérez complètement les leviers de serrage sur les charnières. 3. Maintenez la porte des deux côtés et fermez-la environ aux 3/4. 4. Retirez la porte de l'appareil.
FRANÇAIS 11.5 Éclairage AVERTISSEMENT Il existe un risque d'électrocution. L'éclairage et le diffuseur en verre peuvent être très chauds. Avant de remplacer l'éclairage : • Éteignez l'appareil. • Retirez les fusibles de la boîte à fusibles ou coupez le disjoncteur. ATTENTION Placez un linge au fond de l'intérieur de l'appareil. Cela évitera d'endommager le diffuseur de l'éclairage et la paroi du four. Utilisez toujours le même type d'ampoule.
www.aeg.com Problème Cause probable « Demo » s'affiche à Le mode démo est activé. l'écran et l'appareil ne chauffe pas. Le ventilateur ne fonctionne pas. Solution 1. 2. 3. Si vous ne trouvez pas de solution au problème, veuillez contacter votre revendeur ou le service de maintenance. Les informations à fournir au service de maintenance figurent sur la plaque si- Éteignez l'appareil. Maintenez appuyée la touche jusqu'à ce que l'appareil s'allume ou s'éteigne.
FRANÇAIS AVERTISSEMENT Si l'appareil est installé dans un meuble dont le matériau est inflammable, respectez impérativement les directives en matière de protection contre les incendies de la norme NIN SEV 1000 ainsi que les règlements dictés par la VKF (Association des établissements cantonaux d'assurance incendie). Installation Placez l'appareil en face de l'encastrement et branchez-le à la prise d'alimentation secteur. 1. 380-383 min.
www.aeg.com 594 380-383 380 20 13 min. 560 388 375 min.
FRANÇAIS 594 20 380-383 13 388 375 380 388 380 min. 550 min.
www.aeg.
FRANÇAIS 25 13 20 2x3,5x25 13.1 Branchement électrique Le branchement électrique de l'appareil doit être effectué par un professionnel qualifié. Utilisez un câble d'alimentation de type H05VV-F ou de valeur supérieure. Installez l'appareil en le raccordant à une ligne de courant munie d'une prise électrique. En l'absence de prise électrique, l'installation électrique domestique doit prévoir un dispositif d'isolement ayant une ouverture minimale de 3 mm entre les contacts pour permettre une coupure 14.
www.aeg.com Servicestellen Points de Service Servizio dopo vendita Point of Service 6020 Emmenbrücke Seetalstrasse 11 7000 Chur Comercialstrasse 19 Ersatzteilverkauf/Points de vente de rechange/Vendita pezzi di ricambio/ spare parts service: 5506 Mägenwil, Industriestrasse 10, Tel. 0848 848 111 Fachberatung/Verkauf/Demonstration/Vente/Consulente (cucina)/Vendita 8048 Zürich, Badenerstrasse 587, Tel. 044 405 81 11 Garantie Für jedes Produkt gewähren wir ab Verkauf bzw.
FRANÇAIS collecte officiels SENS est disponible sous www.sens.ch.
892937735-B-332012 www.aeg.