User manual

2. Hold the door t (B) on the top edge of the

door at the two sides and push inwards to

release the clip seal.

3. Pull the door t to the front to remove it.

4. Hold the door glass panels on their top

edge one by one and pull them up out of

the guide

5. Clean the door glass panels.

To install panels follow the procedure in re-

verse. Install the smaller panel first, then the

larger.

WHAT TO DO IF…

WARNING!

Refer to "Safety information" chapter.

Problem Possible cause Solution

The oven does not heat up The appliance is switched off Switch on the appliance

The oven does not heat up The clock is not set Set the clock. Refer to "Setting

the clock"

The oven does not heat up The necessary settings are not

set

Make sure, the settings are cor-

rect

The oven does not heat up The automatic cut-out is

switched on

Refer to „Automatic cut-out“

The oven does not heat up The fuse is released Make sure, if the fuse is the

cause for the malfunction. If

the fuse releases again and

again, refer to an authorized

electrician

The oven lamp does not operate The oven lamp is defective Replace the oven lamp.

The pyrolytic cleaning does not

operate (the clock display

shows „C1“)

The shelf runners/telescopic

shelf runners are not removed

Remove side rails/oven shelf

runners

The pyrolytic cleaning does not

operate (the time display shows

„C3“)

The door is not correctly closed

or door lock is defective

Close the door correctly

What to do if…