User manual

Before maintenance cut the power supply.
Do not use harsh abrasive cleaners or sharp metal
scrapers to clean the glass door since they can
scratch the surface, which may result in shattering of
the glass.
Excess spillage must be removed before the pyrolytic
cleaning. Remove all parts from the oven.
Only use the core temperature sensor recommended
for this appliance.
To remove the shelf supports first pull the front of the
shelf support and then the rear end away from the
side walls. Install the shelf supports in the opposite
sequence.
If the supply cord is damaged, it must be replaced by
the manufacturer, an authorized Service or similarly
qualified persons in order to avoid a hazard.
Ensure that the appliance is switched off before re-
placing the lamp to avoid the possibility of electric
shock.
2.
SAFETY INSTRUCTIONS
2.1 Installation
WARNING!
Only a qualified person must in-
stall this appliance.
Remove all the packaging.
Do not install or use a damaged appli-
ance.
Obey the installation instruction sup-
plied with the appliance.
Always be careful when you move the
appliance because it is heavy. Always
wear safety gloves.
Do not pull the appliance by the han-
dle.
Keep the minimum distance from the
other appliances and units.
Make sure that the appliance is instal-
led below and adjacent safe struc-
tures.
The sides of the appliance must stay
adjacent to appliances or to units with
the same height.
Electrical connection
WARNING!
Risk of fire and electrical shock.
All electrical connections should be
made by a qualified electrician.
The appliance must be earthed.
Make sure that the electrical informa-
tion on the rating plate agrees with
the power supply. If not, contact an
electrician.
4
www.aeg.com