User guide

The door unlocks when the temperature
inside the oven is under safety condi-
tions and the pyrolytic cleaning finishes.
During the pyrolytic cleaning the lamp is
deactivated.
Cleaning reminder
To remind you that the pyrolytic clean-
ing is necessary the cleaning reminder
symbol
flashes in the display after
each deactivation of the appliance for
the next 10 seconds.
The cleaning reminder goes
out:
• After the end of the pyrolytic
cleaning
• When you deactivate it in the
basic settings (refer to "Set-
tings menu")
12.2 Shelf supports
Removing the shelf supports
You can remove the shelf supports to
clean the side walls.
1.
Pull the front of the shelf support
away from the side wall.
1
2
2.
Pull the rear end of the shelf sup-
port away from the side wall and re-
move it.
Installing the shelf supports
Install the shelf supports in the opposite
sequence.
Valid for telescopic runners:
The retaining pins on the tele-
scopic runners must point to the
front.
12.3 Lamp
WARNING!
There is a risk of electrical shock.
The lamp and the lamp glass
cover can be hot.
Before you change the lamp:
• Deactivate the appliance.
• Remove the fuses from the fuse box or
deactivate the circuit breaker.
CAUTION!
Put a cloth on the bottom of the
interior of the appliance. It pre-
vents damage to the lamp glass
cover and the cavity.
Always use the same lamp type.
Replacing the lamp at the cavity
ceiling:
1.
Turn the lamp glass cover counter-
clockwise to remove it.
36
www.aeg.com