User manual

3. Press or to set the End Time
and press . First you set the
minutes and then the hours.
When the set time ends, the signal
sounds for 2 minutes. The display shows
flashing
and the time setting . The
oven turns off automatically.
4. Press a sensor field to stop the
signal.
5. Turn off the oven.
7.5 Setting: Time Delay
1. Set a heating function and
temperature.
2. Press again and again until
starts to flash.
3. Press
or to setthe minutes for
Duration.
4. Press .
5. Press
or to set the hours for
Duration.
6. Press .
The display shows flashing .
7. Press
or to set the End Time
and press . First you set the
minutes and then the hours.
The oven turns on automatically later on,
works for the set Durationand stops at
the set End Time. When the set time
ends, the signal sounds for 2 minutes.
The display shows flashing
and the
time setting . The oven turns off
automatically.
8. Press a sensor field to stop the
signal.
9. Turn off the oven.
When the Time Delay
function is turned on, the
display shows a symbol of
the heating function, with
a dot and . The dot shows
which clock function is on in
the Clock / residual heat
display.
7.6 Setting: Set + Go
You can use the Set + Go function only
when the Duration is set.
1. Set a heating function and
temperature.
2. Set the Duration.
3. Press again and again until the
display shows flashing .
4. Press
to set the Set + Go
function.
The display shows and with an
indicator. This indicator shows which
clock function is activated.
5. Press a sensor field (apart from ON /
OFF) to start the Set + Go function.
7.7 Setting: Minute Minder
1.
Press .
The display shows flashing and "00".
2.
Press
to switch between options.
First you set the seconds, then the
minutes and the hours.
3. Press or to set the Minute
Minder and
to confirm.
4. Press
or the Minute Minder starts
automatically after 5 seconds.
When the set time ends, the signal
sounds for 2 minutes and the display
shows flashing 00:00 and .
5. Press a sensor field to stop the
signal.
7.8 Setting: Count Up Timer
1. To reset the Count Up Timer press:
again and again until display
shows flashing
.
2. Press and hold: . When the
display shows "00:00" the Count Up
Timer starts to count up again.
www.aeg.com
14