User manual
Table Of Contents
- CONTENTS
- 1. SAFETY INFORMATION
- 2. SAFETY INSTRUCTIONS
- 3. PRODUCT DESCRIPTION
- 4. CONTROL PANEL
- 5. BEFORE FIRST USE
- 6. DAILY USE
- 7. CLOCK FUNCTIONS
- 8. AUTOMATIC PROGRAMMES
- 9. USING THE ACCESSORIES
- 10. ADDITIONAL FUNCTIONS
- 11. HINTS AND TIPS
- 11.1 Inner side of the door
- 11.2 Advice for special heating functions of the oven
- 11.3 Baking
- 11.4 Tips on baking
- 11.5 Baking on one level:
- 11.6 Bakes and gratins
- 11.7 Moist Fan Baking
- 11.8 Multilevel Baking
- 11.9 Pizza Setting
- 11.10 Roasting
- 11.11 Roasting tables
- 11.12 Grill
- 11.13 Frozen Foods
- 11.14 Slow Cooking
- 11.15 Defrost
- 11.16 Preserving
- 11.17 Drying
- 11.18 Bread Baking
- 11.19 Food Sensor table
- 12. CARE AND CLEANING
- 13. TROUBLESHOOTING
- 14. ENERGY EFFICIENCY
Problem Possible cause Remedy
The oven does not heat up. The fuse is blown. Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
The lamp does not operate. The lamp is defective. Replace the lamp.
The display shows F111. The plug of the core tem-
perature sensor is not cor-
rectly installed into the sock-
et.
Put the plug of the core tem-
perature sensor as far as
possible into the socket.
The display shows an error
code that is not in this table.
There is an electrical fault. • Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows the
error code again, contact
the Customer Care De-
partment.
Steam and condensation
settle on the food and in the
cavity of the oven.
You left the dish in the oven
for too long.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
The appliance is activated
and does not heat up. The
fan does not operate. The
display shows "Demo".
The demo mode is activa-
ted.
Refer to "Basic Settings" in
"Daily use" chapter.
13.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service centre
is on the rating plate. The rating plate is
on the front frame of the appliance
cavity. Do not remove the rating plate
from the appliance cavity.
We recommend that you write the data here:
Model (MOD.) .........................................
Product number (PNC) .........................................
Serial number (S.N.) .........................................
www.aeg.com40