User manual

10.4 Pyrolysis
CAUTION!
Do not start the Pyrolysis if
the Plus Steam button is
pressed in.
CAUTION!
Remove all accessories and
removable shelf supports.
Do not start the Pyrolysis if
you did not fully close the
oven door. In some models,
the display shows "C3"
when this error occurs.
WARNING!
The oven becomes very hot.
There is a risk of burns.
CAUTION!
If there are other appliances
installed in the same
cabinet, do not use them
when the Pyrolysis function
operates. It can cause
damage to the appliance.
1. Wipe out the cavity with a wet, soft
cloth.
2. Clean the inner side of the door with
hot water, so that the residues do not
burn from the hot air.
3. Set the Pyrolysis function. Refer to
"Daily use" chapter, "Oven
Functions".
4. When flashes, press or to
set the pyrolysis duration:
Option Description
P1 Light clean-
ing. Duration:
1 h 30 min.
P2 Normal clean-
ing. Duration:
3 h.
After 2 seconds the pyrolysis starts.
You can use the END function to delay
the start of the cleaning.
During the pyrolysis the oven lamp is off.
5. To change the default length of the
pyrolysis (P1 or P2), press
to set
, and then press or .
6. When the oven is at the set
temperature, the door locks. The
display shows and the bars of the
heat indicator until the door unlocks.
7. When pyrolysis is completed, the
display shows the time of day. The
oven door stays locked.
8. When the oven is cool again, a signal
sounds and the door unlocks.
10.5 Cleaning reminder
To remind you that the pyrolysis is
necessary, PYR flashes in the display for
10 seconds after each activation and
deactivation of the oven.
The cleaning reminder
goes out:
• after the end of the
pyrolysis.
• if you press and at
the same time while PYR
flashes in the display.
10.6 Aqua cleaning
The Aqua cleaning procedure uses
humidity to help remove remaining fat
and food particles from the oven.
1. Put 200 ml of water into the cavity
embossment at the bottom of the
oven.
2. Set the True Fan Cooking PLUS
function
and press the Plus
Steam button .
3. Set the temperature to 90 °C.
4. Let the appliance operate for 30
minutes.
5. Deactivate the appliance and let it
cool down.
6. When the appliance is cool, clean the
inner surfaces of the oven with a
cloth.
WARNING!
Make sure that the
appliance is cool before
you touch it. There is a
risk of burns.
www.aeg.com30