Instruction Manual

2. Hold the door trim (B) on the top edge

of the door at the two sides and push

inwards to release the clip seal.

3. Pull the door trim to the front to re-

move it.

4. Hold the door glass panels on their top

edge one by one and pull them up out

of the guide

5. Clean the door glass panels.

To install panels follow the procedure in re-

verse. Install the smaller panel first, then the

larger.

WHAT TO DO IF…

WARNING!

Refer to "Safety information" chapter.

Problem Possible cause Solution

The oven does not heat up The appliance is switched off Switch on the appliance

The oven does not heat up The clock is not set Set the clock. Refer to "Setting

the clock"

The oven does not heat up The necessary settings are not

set

Make sure, the settings are cor-

rect

The oven does not heat up The automatic cut-out is

switched on

Refer to „Automatic cut-out“

The oven does not heat up The fuse is released Make sure, if the fuse is the

cause for the malfunction. If

the fuse releases again and

again, refer to an authorized

electrician

The oven lamp does not oper-

ate

The oven lamp is defective Replace the oven lamp.

The display shows C2 You want to start the defrost

function but you did not re-

move core temperature sensor

plug from the socket.

Remove the core temperature

sensor plug from the socket

What to do if… 31