User manual

Problem Possible cause Remedy
The lamp does not operate. The lamp is defective. Replace the lamp.
The display shows F111. The plug of the core tem-
perature sensor is not cor-
rectly installed into the sock-
et.
Put the plug of the core tem-
perature sensor as far as
possible into the socket.
The display shows an error
code that is not in this table.
There is an electrical fault. • Turn off the oven with the
house fuse or the safety
switch in the fuse box
and turn it on again.
• If the display shows the
error code again, contact
the Customer Care De-
partment.
Steam and condensation
settle on the food and in the
cavity of the oven.
You left the dish in the oven
for too long.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
The appliance is activated
and does not heat up. The
fan does not operate. The
display shows "Demo".
The demo mode is activa-
ted.
Refer to "Basic Settings" in
"Daily use" chapter.
The appliance does not re-
tain the water drawer after
you insert it.
You did not assemble the lid
of the water drawer correct-
ly.
Assemble the lid of the wa-
ter drawer correctly.
Water comes out of the wa-
ter drawer after you carry it
or put it inside the appli-
ance.
You did not assemble the lid
of the water drawer correct-
ly.
Assemble the lid of the wa-
ter drawer correctly.
Water comes out of the wa-
ter drawer after you carry it
or put it inside the appli-
ance.
You did not assemble the
wave-breaker correctly.
Assemble the wave-breaker
in the body of the water
drawer correctly.
The appliance does not re-
tain the water drawer after
you push it on the cover.
You did not fully press the
water drawer body.
Insert the water drawer body
in the appliance by pushing
it until it reaches to the end.
The water drawer is difficult
to clean.
You did not remove the lid
and the wave-breaker.
Refer to "Cleaning the water
drawer".
The descaling procedure is
interrupted before it finishes.
There was a power cut. Repeat the procedure.
The descaling procedure is
interrupted before it finishes.
The function was stopped by
the user.
Repeat the procedure.
www.aeg.com56