User manual

You can buy our products at
www.aeg.com/shop and at the best
retailer shops.
13.3 Removing the shelf
supports
Before maintenance, make sure that the
oven is cool. There is a risk of burns.
To clean the oven, remove the shelf
supports.
1. Pull carefully the supports up and out
of the front catch.
2. Pull the front end of the shelf support
away from the side wall.
3. Pull the supports out of the rear
catch.
Install the shelf supports in the opposite
sequence.
13.4 Pyrolytic Cleaning
CAUTION!
Remove all accessories.
Do not insert water in the
water tank during the
pyrolytic cleaning. Filling the
water tank during pyro cycle
will stop the pyrolytic
cleaning. After this
operation pyro cycle will
start from the beginning.
The pyrolytic cleaning
procedure cannot start:
• if you did not remove the core
temperature sensor plug from the
socket.
• if you did not fully close the oven
door.
CAUTION!
If there are other appliances
installed in the same
cabinet, do not use them
when the function Pyrolytic
Cleaning operates. It can
cause damage to the
appliance.
1. Activate the appliance and select
from the main menu the function
Pyrolytic Cleaning . Press to
confirm.
2. Put the baking tray on the first shelf
position to collect water from the
water tank. Press
to start water
tank emptying procedure.
3. When the procedure ends remove all
accessories and the side grids.
Remove the remaining food
manually. Clean the inner side of the
door with hot water, so that the
residues do not burn from the hot air.
Press to start Pyrolytic Cleaning
4. Press
or to choose the
duration of the cleaning procedure:
Option Description
Quick 1 h
Normal 1 h 30 min
Intense 3 h
Press to confirm.
To stop the pyrolytic
cleaning before it is
completed, deactivate the
appliance.
When the pyrolytic cleaning
starts, the appliance door is
locked and the lamp does
not work.
www.aeg.com44