Manual

English
31
8 RAN button (random playback)
9 MUTE button
10 EQ button (Equalizer)
11
button (On/Off)
First Use of the Device/Introduction
NOTE:
The device is operated primarily with the remote control.
Thus the descriptions refer to the buttons on the remote
control. Some buttons are also on the device. Buttons with
the same name have the same function.
Selectaproperplaceforthedevice.Adry,levelandslip
proof surface is suitable.
Makesurethedeviceisventedsufciently!
Removetheprotectivelmfromthedevice,ifpresent.
Power supply
Insertthegridplugintoaproperlyinstalledthreeprong
socket.
Makesurethegridvoltagecorrespondstothegureson
the rating plate.
NOTE:
Disconnect from mains power supply during longer periods
of non-use.
Insert/Replace Battery in Remote Control
Openthebatterycompartmentontheundersideofthe
remote.
InsertAAA/R031.5Vtypebatteries.Payattentiontothe
correct polarity (see bottom of battery compartment)!
Closethebatterycompartment.
If the remote is not in use for a lengthy period of time, please
remove the battery to prevent the battery acid from “leaking”.
WARNING:
Donotexposethebatteriestointenseheat,suchas
sunlight, re or similar. Danger of explosion!
Keepbatteriesoutofthereachofchildren.Theyare
not toys.
Donotforcebatteriesopen.
Avoidcontactwithmetallicobjects.(Rings,nails,screws
etc.) Danger of short circuits!
Shortcircuitsmayoverheatorevenignitebatteries.
This may lead to combustion.
Whentransportingthebatteries,covertheterminalsfor
your safety with an adhesive strip.
Ifabatteryleaks,donotrubtheuidintotheeyesor
the skin. If acid comes into contact with the eyes, rinse
with puried water and seek medical advice if symp-
toms persist.
CAUTION:
Differentbatterytypesornewandusedbatteriesmay
not be used together.
Batteriesmustnotbedisposedofinthegarbage.
Please bring used batteries to competent collection
centers or back to the dealer.
General Operation
Switch device on/off
Withthe
button (11/3), you can switch the unit between
standby and operating mode. In standby, the pilot lamp
(5 on the device) lights red.
Todisconnecttheunitcompletelyfromthemains,pull
the mains plug from the socket.
NOTE:
After about 60 minutes without signal, the device will auto-
matically switch to Standby.
Volume
By pressing the VOL+/VOL- buttons (6) you can adjust the
desired volume.
NOTE:
Keep the >/< buttons (4) pressed on the device to set the
device to the desired volume.
Infrared Remote Control
For wireless control within a distance of 5 m. If the distance
decreases you should change the batteries. For proper
operation mind a clear view between the remote control and
the sensor on the device.
Sound Settings
(Preset equalizer function). Different sound modes are
available. Press the EQ button (10) repeatedly, to select the
individual sound modes. Select the sound mode that you like
best by listening to it.
NOTE:
If necessary, change the EQ setting in your playback unit to
create the best sound.
MUTE (9)
For immediate muting of the volume. Press MUTE again to
cancel the function.
NOTE:
If the function has been activated, the indicator light (5) will
ash slowly.