Manual

English
33
1. Press the MODE button (2/1) repeatedly until the indica-
tor light (5) illuminate pink.
2. Connect a USB storage device directly into the port.
Playback then begins.
For operation, please refer to the section “Description of the
controls”.
NOTE:
• Alwaysdirectly connect a USB storage medium to the
USB port to prevent any malfunctions.
• TheUSBportisnotdesignedforchargingexternal
devices.
• The5VUSBvoltageisalsoactivatedinstandby.
CAUTION:
Before removing the USB storage device, switch the device
to another mode using the MODE button (2/1).
Description of the controls
(1/2)
You can pause and continue music playback. Press again to
continue playback.
NOTE:
The activated function cannot be displayed for technical
reasons.
(5/4)
Press1x= Willre-startthecurrentsongfromthebegin-
ning. (Only in Bluetooth mode)
Press2x= Skiptotheprevioussong.
Press3x= Skiptothesongbeforetheprevioussong.
(5/4)
Presstoskiptothenextsongandthefollowingsongs.
RPT (3) (only in USB mode)
Activates the Repeat function.
• Pressthebuttontorepeatonlythecurrenttitle.The
indicator light (5) flashes quickly.
RAN (8) (only in USB mode)
Activates random playback. All titles are played back in a
random sequence. To deactivate the function again, press
theRPTbutton2x.
NOTE:
The activated function cannot be displayed for technical
reasons.
/ (7) (only in USB mode)
Iffoldersexist,thenextorpreviousfolderisselected.The
playback is stopped. Press the OK button (4), to start the
playback in the selected folder.
OK (4) (only in USB mode)
Playback starts in the previously selected folder.
Cleaning
CAUTION:
Do not submerge the device in water.
• Beforecleaningdisconnectfrommainspowersupply.
• Cleanthedevicewithasoftdampclothwithoutdeter-
gents.
Troubleshooting
Fault Cause Solution
Unit cannot be
operated.
Unit crashes
and “hangs”.
Disconnect from the
mains for around
5 seconds. Then switch
the unit on again.
No audio signal
via the Bluetooth
connection
Speaker is not
paired to the
audio source.
Check whether a connec-
tionexists.Ifnecessary,
pair the speaker again to
the audio source.
Volume too
low
Increase the volume on
the speaker
Increase the volume on
the audio source.
Speaker cannot
be connected
Pairing does
not work
Check whether the audio
source supports the
A2DP protocol.
Audio source
is switched off
Switch on the audio
source
Bluetooth is
switched off
at the audio
source.
Switch on the Bluetooth
function in the audio
source.
Bluetooth
version is not
supported.
Use a different playback
unit.
Music tracks are
played back via
USB in the wrong
sequence.
Random
playback is
activated.
PresstheRPTbutton2x
(3).