User manual

English
33
NOTE:
• Someofthemobilephonebrandshaveanenergy-sav
-
ing mode. Deactivate the energy-saving mode as it can
otherwise result in problems during the data transfer
through Bluetooth.
• Tobeabletotransferaudiodata,Bluetoothneedsto
stay activated in your player. Observe the operation
manual of your player.
• Ifamobilephoneonwhichyouareplayingmusicre-
ceives a call, the music will be interrupted. The “Master”
speaker emits a ringtone. Press the
/
button (3) on
the “Master” to answer the call. Audio will be rendered
via the “Master” speaker. Use the microphone (10) of
the “Master” speaker for talking or transfer the call
to your mobile phone. Refer to the indicators in the
display of your mobile phone. After the call has been
finished, music playback will continue.
Description of the Bluetooth Operation
Buttons
/
(3)
Press the button briefly to interrupt the playback. Pressing the
button again continues the playback from the same position.
NOTE: Bluetooth music playback
Your playback device must support this function. Depend
-
ing on the device, it may be necessary to start the music
app in advance on your playback device.
Speakerphone operation (
/
)
• Pressthebuttontoanswerornishanincomingcall.
• Pressandholdthisbuttontorejectanincomingcall.
• Pressthisbuttontwicetoredialthelastdialednumber.
NOTE:
In paired mode, the speakerphone operation is only avail
-
able on the “Master” speaker.
(1)
Press once = Starts the current title again from the
beginning.
Press twice = Jumps to the preceding title.
Press three times = Plays a preceding title, etc.
(2)
Youcanusethisbuttontojumptothenextorovernexttitle
etc.
Cleaning
CAUTION:
Do not submerge the device in water.
• Beforecleaningdisconnectfrommainspowersupply.
• Cleanthedevicewithasoftdampclothwithoutdeter
-
gents.
Troubleshooting
Fault Cause Solution
Unit cannot be
operated.
Unit crashes and
“hangs”.
Turn off the device using
the switch on the rear
side and then turn it on
again.
Speaker cannot
be turned on
Rechargeable
battery empty
Charge the battery
(

page 30)
No audio
signal via the
Bluetooth con
-
nection
Speaker is not
paired to the
audio source.
Check whether a connec-
tionexists.Ifnecessary,
pair the speaker again to
the audio source.
Volume too low Increase the volume on
the speaker.
Increase the volume on
the audio source.
Speaker cannot
be connected
Pairing does not
work
Check whether the audio
source supports the
A2DP protocol.
Audio source is
switched off
Switch on the audio
source
Bluetooth is
switched off at
the audio source.
Switch on the Bluetooth
function in the audio
source.
Bluetooth
version is not
supported.
Use a different playback
unit.
Audio cable con
-
nected to the
LINE IN socket.
Disconnect the audio
cable.
The speakers
cannot be
paired (paired
mode)
Bluetooth con
-
nection faulty
Turn off both speakers
using the switch on the
rear side. Then turn both
devices on and pair them
again.
Audio cable con
-
nected to the
LINE IN socket.
Disconnect the audio
cable.