Operating instructions
Table Of Contents
- 1 Notes on these Operating Instructions
- 2 General Information
- 3 Safety
- 4 Set-Up and Operation
- 5 Commissioning
- 6 Electrical Start-Up
- 7 Interfaces and communication
- 8 Signalling and Error Correction
- 9 Parallel operation
- 10 Maintenance
- 11 Storage, Dismantling and Disposal
- 12 Glossary
17
EN
♦ Assure for no power
♦ Ground and short circuit system
♦ Cover or seals adjacent components still under power
3.3 Qualified personal
The Protect C may only be transported, setup, connected and
maintained by qualified personnel, that is aware do the legal
security and installation regulations and knows how to apply
them. All executions have to be supervised by responsible
qualified personnel.
The qualified personnel have to be authorised by the
responsible person for security rights affairs to execute the
necessary tasks.
Qualified personnel have
♦ an education and experience in the relevant area of
operation,
♦ know the applicable norms, rules, regulations and
accident preventions rules,
♦ are educated in the functionality and the operation of
the Protect C,
♦ can identify and prevent dangers.
Regulations and definitions for qualified personnel are
included in DIN 57105 / VDE 0105, part 1.
3.4 Safety Instructions for Protect C
The UPS carries high voltage. The unit may
only be opened by trained and qualified
personnel.
Repairs may only be carried out by
qualified customer service staff!
The output may be live, even if the UPS is not
connected to the mains, since the UPS has its
own internal power supply (battery)!
For health and safety reasons, the unit must be
earthed
correctly!