Operating instructions
Table Of Contents
- 1 Notes on these Operating Instructions
- 2 General Information
- 3 Safety
- 4 Set-Up and Operation
- 5 Commissioning
- 6 Electrical Start-Up
- 7 Interfaces and communication
- 8 Signalling and Error Correction
- 9 Parallel operation
- 10 Maintenance
- 11 Storage, Dismantling and Disposal
- 12 Glossary
35
EN
Please shut down the entire system if you cannot
solve any problems which occur.
Press the OFF
button for about 2 seconds. Disconnect the UPS
from the mains by pressing the m
ains input circuit
breaker
(Pos 3, page 26/27). Please contact our
hotline
(page 5).
When all displays are lit as described, switch on 8.
your loads one after the other. Note the maximum
permitted UPS load when doing this.
Behaviour when switching off:
The
behaviour after switching off the UPS with the
mains switch (OFF) can be defined with the
Software CompuWatch. The UPS can switch to
bypass mode or can be switched of right away.
i
i