Operation Manual

g
38
0 Remove the water tank from the cof-
fee machine (Fig. 7).
0 Fill the water tank with fresh cold
water (Fig. 8).
3
Pour only fresh cold water in the water
tank. Never put in other liquids, e.g.
mineral water or milk.
0 Replace the water tank (Fig. 7). Press
the tank firmly in, to ensure that the
water tank valve opens.
3
If for instance, water has to be refilled
during coffee dispensing, the „Fill
water tank“ indicator (Fig. 3, k)
flashes, the display indicates «REFILL
WATER». Coffee preparation is inter-
rupted. Fill the water tank!
3
To always be sure of a rich coffee, with
a full aroma, you should:
• change the water in the water tank
daily,
• wash the water tank at least once per
week in normal washing-up water (not
in the dishwasher). Then rinse with
fresh water.
5.3 Switching on for the first time
When you place the machine in use for
the first time, the automatic switching
on process only continues if you have
selected the desired language.
0 Switch on the machine with the „On/
Off“ key (Fig. 3, h) (Fig. 9). The red
indicator light comes on
3
The machine is set at the factory to the
display language «DEUTSCH» (Ger-
man).
3
To select a different language, proceed
with „Setting language“ page 45.
0 If you wish to select «DEUTSCH»,
press the „OK“ key (Fig. 3, g). German is
now programmed.
3
After programming the display returns
automatically in the main menu to the
menu point «LANGUAGE».
0 To start the switching on process, press
the „Menu“ key (Fig. 3, f) or wait
ca. 30 sec. For the machine to auto-
matically start with the switching on
process.
3
The display briefly indicates «CAFFÈ
PERFETTO».
The machine now heats up (display
indication «UNIT HEATS») and sub-
sequently performs a rinsing cycle (dis-
play indication «UNIT RINSES»). On
completion of the rinsing cycle, the
machine is ready for use. The display
indication now appears according to
the basic setting.
5.4 Switching on the machine
Each time before switching on, make
sure there is water in the water tank
and replenish if necessary. The machine
requires water for the automatic rins-
ing cycles with each switching on and
switching off process.
0 Switch the machine on with the „On/
Off“ key (Fig. 3, h) (Fig. 9). The red
indicator light comes on, the display
indicates briefly «CAFFÈ PER-
FETTO».
3
Immediately after being switched on
the machine runs through a set-up
cycle. The noises occurring are per-
fectly normal.
3
During the heating-up phase (ca.
60 seconds) the „Coffee machine heat-
ing“ indicator (Fig. 3, i) flashes (dis-
play indication «UNIT HEATS»).
3
After the operating temperature has
been reached, the coffee machine car-
ries out an automatic rinsing cycle.
(display indication «UNIT RINSES»).
The water flows into the drip tray. The
„Unit heats“ indicator (Fig. 3, i) lights
continuously.
The coffee machine is now ready to
use. The indication shown in the dis-
play depends on the last selected cof-
fee mode.
822_949_320 CP3500_denepf.book Seite 38 Freitag, 16. September 2005 12:04 00