Operation Manual

g
43
1
Attention! Impurities from dried milk
residues in the steam nozzle. Take care
not to immerse the steam nozzle in the
milk far enough to cover the air intake
opening at the top of the steam nozzle.
Otherwise milk can be sucked into the
nozzle and cause impurities in the
steam nozzle.
0 Turn the Selection dial for steam and
hot water (Fig. 1, D) to the position
(Fig. 16). The display shows the
steam process (indication «STEAM»).
The milk is frothed.
3
Hold the mug steady during the froth-
ing. The nozzle should not be allowed
to touch the bottom of the mug and
cut off the steam supply. Froth the milk
to at least twice its volume.
0 To end the frothing, turn the Selection
dial for steam and hot water (Fig. 1, D)
to the position and then remove the
vessel (Fig. 16). The display returns to
the steam readiness indication (indica-
tion «STEAM READY – OPEN
STEAM NOZZLE»).
1
Caution! Danger of scalding from hot
milk spray! Switch the steam off,
before removing the mug with the
frothed milk.
0 Exit the steam mode by pressing the
„Steam Pre-selector“ key (Fig. 3, a)
or wait ca. 60 sec., for the machine to
automatically return to the coffee
mode; the indication is extinguished.
Now the machine is once again ready
for making coffee; the last selected
coffee setting is shown in the display.
0 Each time you have frothed milk, let
off some hot water through the nozzle
for a short time by setting the Selec-
tion dial for steam and hot water (Fig.
1, D) to the position. This is nec-
essary to prevent milk residues drying
inside the nozzle, and thereby blocking
it. Use a suitable container to catch the
water. During this process the display
shows «HOTWATER». Then return
the Selector dial to the position ; the
last selected coffee setting is shown in
the display.
0 Remove the frothing aid after each use
(Fig.17). For this, take hold of the
frothing aid by the black seal and dis-
engage the bayonet connector by
turning it slightly anticlockwise. Rinse
off the milk residues under running
water. Wipe the steam nozzle with a
damp cloth.
1
Caution! Danger of burns from the
frothing aid! Hold the frothing aid only
by the black seal.
9 Preparing Hot Water
The hot water can be used to pre-heat
cups and for making hot drinks, e.g. tea
or instant soups.
1
Caution! Danger of scalding when the
hot water nozzle is activated! Hot
water or steam output can cause
scalding. Activate the hot water nozzle
only when a container is under the hot
water nozzle.
0 Place a container under the hot water
nozzle. Set the Selection dial for steam
and hot water (Fig. 1, D) to the
position (Fig. 18). Hot water is ready;
the display shows «HOTWATER».
0 After you have dispensed the hot water
turn the Selection dial for steam and
hot water (Fig. 1, D) back to the
position (Fig. 18) and remove the con-
tainer.
822_949_320 CP3500_denepf.book Seite 43 Freitag, 16. September 2005 12:04 00