Operation Manual

g
51
3
During the cleaning process the display
shows the following indications alter-
nately:
•«CLEANING 1 <1-6>»:
The program carries out 6 cleaning
cycles. The pauses enable the cleaning
solution to take effect. The cleaning
cycles are counted off in the display.
•«IN PROCESS»
The bar indication in the bottom line
increases with the advance of the
pause duration.
3
In the event of a power failure or
interruption, the program must be
restarted!
The cleaning process takes ca.
8 minutes. Then the following is shown
in the display:
•«WAIT»
•«WASTE CONTAINER – PRESS
OK»
0 Empty and replace the container. Then
press the „OK“ key (Fig. 3, g).
•«REFILL WATER – PRESS OK»
0 Remove the water tank, refill water
and replace. Then press the „OK“ key
(Fig. 3, g).
•«CLEANING COMPLETED»
When this message appears, the clean-
ing program is ended.
0 Turn the bean container to the desired
position. The machine is now ready for
use and in the status of the last
selected coffee mode.
3
After running the cleaning program,
you are advised to throw away the first
cup of coffee from the machine.
13.7 Running the Descaling Program
The descaling program allows you to
simply and effectively descale your
coffee machine. The coffee machine
should be regularly descaled, every
4-6 months, at the latest when you are
instructed to do so by the display-
indication «CARRY OUT DES-
CALING».
1
Important: Do not under any circum-
stances use descalers based on formic
acid or vinegar or pure lemon juice, as
these can damage the appliance. Pow-
dered descalers are not recommended.
Use only AEG descaling tablets.
If other descaling agents are used, AEG
accepts no liability for any damage. You
can obtain descaling tablets from spe-
cialist retailers (E-No. 900195537/7) or
from the AEG Service Line.
3
The descaling process takes ca.
45 minutes and should not be inter-
rupted. In the event of a power failure
or interruption, the program must be
restarted!.
0 Before starting the descaling program,
clean the coffee-making unit (refer to
„Cleaning the Coffee-making Unit“
page 49).
0 Press the „Menu“ key (Fig. 3, f) .
The menu point «LANGUAGE»
appears.
0 Press the paging keys or (Fig. 3, c
or d) until the menu point
«DECSALING» appears.
0 Confirm the menu point with the „OK“
key (Fig. 3, g). The display shows
«START DESCALING».
0 Confirm with the „OK“ key (Fig. 3, g).
The display shows «PREPARE DES-
CALING».
To prepare for descaling, follow the
instructions in the display.
•«REFILL WATER <min.800 ml>
- PRESS OK»
0 Fill the water tank with at least 800 ml
of warm water. Then press the „OK“ key
(Fig. 3, g).
•«DESCALER IN WATERTANK –
PRESS OK»
0 Place 2 descaling tablets in the water
tank (Fig. 38). Refit the water tank
after the tablets have dissolved; this
takes ca. 5-7 minutes. Then press the
„OK“ key (Fig. 3, g).
•«WAIT»
The brewing unit is positioned.
822_949_320 CP3500_denepf.book Seite 51 Freitag, 16. September 2005 12:04 00