User manual

75
What to do if ...
If you cannot rectify the fault with the help of the information
given above, please contact your local Service Force Centre.
Symptom Possible cause Solution
The cooking zones do
not function.
The appropriate cooking
zone has not been switched
on.
Switch on the cooking zone.
The circuit breaker (at the
household fuse box) has
tripped or the fuse has
blown.
Check the circuit breaker or
fuse.
“-” appears in the
cooking zone display
The mains switch N has
been switched off and the
ring switch was not in the
off position.
Turn the ring switch to “0”
and then set the required
heat setting.
The oven does not heat
up.
The oven has not been
switched on.
Switch on the oven.
The time has not been set. Set the time.
The necessary settings have
not been made.
Check the settings.
The oven safety cut-out has
been activated.
See
Safety Cut-out.
The circuit breaker (at the
household fuse box) has
tripped or the fuse has
blown.
Check the fuse.
If the circuit breaker trips or
the fuse blows several times,
please call an approved elec-
trician.
The oven lighting does
not come on.
The oven light bulb has
blown.
Replace the light bulb in the
oven (see Cleaning and Care).
Pyroluxe is not func-
tioning (“tEL” appears
in the time display).
The oven shelf runner has
not been removed.
Remove oven shelf runner.
The oven door is locked The appliance is not plugged
in; The door lock has been
activated.
Plug in the appliance and
wait at least 10 seconds until
the red temperature pilot
light goes off.