DD 8890 - CHDD 8820 CHDD 8890 Dunstabzugshaube Afzuigkap Hotte Cooker Hood Campana extractora Montage- und Gebrauchsanweisung Installatie- en gebruiksaanwijzing Notice dutilisation et dinstallation Operating and Installation Instructions Instrucciones de montaje y manejo
Contents Safety warnings For the user For the installer 53 53 53 Description of the Appliance Extractor version Filter Version 55 55 55 Control Panel Control device for grease and charcoal filters Grease filter LED (F) Charcoal filter LED (C) Resetting the saturation indicator 56 57 57 57 57 Maintenance and care Cleaning the hood Metal grease filter Removing the metal grease filter Charcoal filter Changing the light bulb 58 58 58 58 59 60 What to do if 61 Special accessories 62 Technical assista
Safety warnings For the user The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. Always cover lighted elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal fired cookers it is essential to avoid open flames. Also, when frying, keep the deep frying pan on the cooker top/ cooker under careful control. The hot oil in the frying pan might ignite due to overheating.
The national Standard on fuel-burning systems specifies a maximum depression of 0.04 mbar in such rooms. The air outlet must not be connected to chimney flues or combustion gas ducts. The air outlet must under no circumstances be connected to ventilation ducts for rooms in which fuel-burning appliances are installed. The air outlet installation must comply with the regulations laid down by the relevant authorities.
Description of the Appliance The hood is supplied as an extractor unit and can also be used with a filtering function by fitting one charcoal filter. You will need an original AEG charcoal filter for this function (Available from your local AEG Service Force Centre). Only for CHDD 8890: The cooker hood is supplied ready for use as a recirculation hood and may be used for extraction by removing the charcoal filter which has been fitted inside the cooker hood.
Control Panel Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking, you will then get an under pressure in the kitchen. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. The control switches are located on the units front panel. Fig.
Control device for grease and charcoal filters This hood is fitted with a device that signals when it is necessary to clean the grease filter or the charcoal filter (if the hood is used in the recirculation version with a charcoal filter). On delivery, the hood is not supplied with a charcoal filter, so the saturation indicator will be disabled.
Maintenance and care The hood must always be disconnected from the electricity supply before beginning any maintenance work. Cleaning the hood Clean the outside of the hood using a damp cloth and a mild detergent. Never use corrosive, abrasive or flammable cleaning products. Never insert pointed objects in the motors protective grid. Wash the outside surfaces using a delicate detergent solution. Never use caustic detergents or abrasive brushes or powders.
Charcoal filter The charcoal filter should only be used if you want to use the hood in the recirculation function. To do this you will need an original AEG charcoal filter (available from your local Service Force Centre). Cleaning/replacing the carbon filter Unlike other carbon filters, the LONGLIFE carbon filter can be cleaned and reactivated. At normal use the filter should be cleaned every second month (when using the hood 2,5 hours per day, in avarage).
Warning Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Changing the light bulb Disconnect the cooker hood from the main supply. Remove the lamp cover, use a screw driver as a lever.
What to do if If your appliance fails to work properly please carry out the following checks. Symptom Solution The cooker hood will not start... Check that: The hood is connected to the electricity supply. Check that a fan speed has been selected The cooker hood is not working effectively.. Check that: The fan speed is set high enough for the task. The grease filters are clean. The kitchen is adequately vented to allow the entry of fresh air.
Special accessories Charcoal filter KF20 E-Nr. 942 120 600 Technical assistance service (not for UK) You are welcome to telephone our technical assistance service (see list of technical assistance centres) whenever you need information or in the unlikely event of a fault. When calling, please be ready to specify: 1. The model code number 2. The serial number (E-Nr.) 3. The manufacturing number (F-Nr.) This information is shown on the registration plate inside the unit behind the grease filter.
Technical Specifications Model DD 8890 CHDD 8890 Dimensions - extractor version (in cm): Height 70-113 Width 89,8 Depth 50 Dimensions - filter version (in cm): Height 78-122 Width 89,8 Depth 50 Maximum absorbed power: 215 W Motor absorption: 1 x 175 W Lighting: 2 x 20 W Lengthof the cable: 150 cm Electrical connection: 220 - 240 V CHDD 8820 68,5-113,4 119,8 46 77,2 - 123 119,8 46 275 W 1 x 175 W 4 x 20 W 150 cm 240 V Mounting accessories included 1 chimney support 1 reduction flange Ø 125-120 mm 1 defl
Electrical connection (not for UK) Safety warnings for the electrician Before connecting the appliance to the power supply, check that the voltage indicated on the rating plate corresponds to the mains power supply available. Appliances fitted with a plug can be connected to any standard power socket within easy access. Should it be necessary to provide a fixed connection, the hood must only be installed by an electrician authorised by the local electricity board.
Wall unit mounting - Fig. 6 First decide how the hood is to operate (extractor or filter). If you decide to use the hood in the extractor version we suggest to position the upper section of the chimney so that the oulet slots are not visible once installed, if the hood is used in the filtering version ENSURE that the side with the slots pointing upwards (see also A-B-C sequence on on Fig. 6). B 180° A C - OK! Fig. 6 Wall unit mounting - Fig.
17a 1 17a 17b H G G 11 11 12 17b F F 4-13 CHDD 8820 16 4-13 8 18 8 15 3 B 65 5 9 10 2 6 7 9 10 14 14 Fig.
From the Electrolux Group. The world´s No.1 choice. The Electrolux Group is the world´s largest producer of powered appliances for kitchen, cleaning and outdoor use. More than 55 million Electrolux Group products (such as refrigerators, cookers, washing machines,vacuum cleaners, chain saws and lawn mowers) are sold each year to a value of approx. USD 14 billion in more than 150 countries around the world. AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www.aeg.hausgeraete.de http://www.aeg.co.
