Operation Manual

3
53mm
182mm
INSTALLATION
Choose the mounting location where
the unit will not interfere with the
normal driving function of the driver.
Before finally installing the unit,
connect the wiring temporarily and
make sure it is all connected up
properly and the unit and the system
Use only the parts included with the
unit to ensure proper installation. The
use of unauthorized parts can cause
Consult with your nearest dealer if
installation requires the drilling of
holes or other modifications of the
Install the unit where it does not get
in the driver's way and cannot injure
the passenger if there is a sudden
O
If installation angle exceeds 30 from
horizontal, the unit might not give its
Notes:
work properly.
vehicle.
malfunctions.
30
optimum performance.
stop,like an emergency stop.
DIN FRONT/REAR-MOUNT
This unit be can properly installed either
from "Front"(conventional DIN
Front-mount) or "Rear"(DIN Rear-mount
installation, utilizing threaded screw holes
at the sides of the unit chassis). For
details, refer to the following illustrated
installation methods.
TAKE OUT SCREW BEFORE
INSTALLATION
Before install the unit, please remove
the two screws .
Take out screw
before installation
DIN FRONT-MOUNT (Method A)
Installation Opening
This unit can be installed in any
dashboard having an opening as show
below:
Installing the unit
Be sure you test all connections first,
and then follow these steps to install
the unit.
Avoid installing the unit where it
would be subject to high temperature,
such as from direct sunlight, or from
hot air, from the heater, or where it
would be subject to dust, dirt or
excessive vibration.
1.
3.
2.
4.
Make sure the ignition is turned off,
and then disconnect the cable from the
vehicle battery's negative (-) terminal.
Disconnect the wire harness and the
antenna.
Press the release button on the front
panel and remove the control panel
(see the steps of "removing the front
panel").
Lift the top of the outer trim ring then
pull it out to remove it.
The two supplied keys release tabs
inside the unit's sleeve so you can
remove it. Insert the keys as far as
5.