Operation Manual

OPERATION
9
Volume Bass Treble Balance Fader
FACEPLATE RELEASE
Press OPEN/CLOSE button (7) to slide
down the removable faceplate.
SOUND ADJUSTMENT
Press SEL button (10) to select
the desired adjustment mode. The
adjustment mode will change in the
following order:
shortly
TA SEEK or ALARM
PI SOUND or MUTE
MASK DPI or ALL RETUNE L or S
BEEP 2'nd or OFF
a) TA SEEK OR TA ALARM
- TA SEEK mode:
When newly tuned station does not
receive TP information for several
seconds, the radio retunes to next
station which has not the same
station (PI) as the last station, but
has the TP information.
When TP information gets lost at the
current station for retune time which
is set by RETUNE SHORT (30 sec.)
or RETUNE LONG (90 sec.), the
radio start to retune to next same PI
station. When same PI station does
not catch in 1 cyclic search, the
- TA ALARM mode:
When this mode is selected, any
automatic retune mode is not
activated. Only double beep sound
(ALARM) is output.
When newly tuned station does not
have TP information for several
seconds, beeps come out.
When TP information gets lost at the
current station for retune time, the
beep sound is out-putted.
When newly tuned station has no
RDS signal, "PI SEEK" is
suppressed somewhat.
b) PI SOUND or PI MUTE
While AF switching is implemented in
C201 station, AF can switch to 100
MHz, which is non genuine AF (where,
different PI with same AF) in short
"DIP".
If a car cruises that critical area back
and forth, an oscillation
phenomenon can be occurred,
because the different PI code can be
received from 100 MHz with "XXX"PI.
The car radio has special procedure
to reduce even this kind of
unavoidable situation however there
is a limit to be escaped from this
serious case perfectly.
In that serious case, 2 mode is
selectable as follows:
100
100
PI: C201
PI: XXX
98
90
- PI SOUND mode:
When above different PI sound (DIP)
is heard once in a while, the DIP's
sound will be heard for a short time.
- PI MUTE mode:
Under above same situation, a mute
sound will be heard for a short time.
SWITCHING ON/OFF THE UNIT
Switch on the unit by pressing any button
(except button (7) and eject button(4).
When system is on, press POWER
button (9) to turn off the unit.
By rotating the VOLUME knob (11)
clockwise or counter-clockwise, it is
possible to adjust the desired sound
quality.
Press SEL button (10) for several
seconds, it is activated as cyclical mode
of following functions for user's selection.
radio retunes to next station with TP
information.