Operation Manual

68
ENGLISH
3.2 Insert Batteries
Open the battery compartment at the rear.
Inser 2 x 1.5V batteries type R03/AAA ein. Observe correct polarity (see battery compartment)!
Close the battery compartment again.
During longer periods of non-use remove the batteries to avoid battery leakage.
WARNING:
Protect batteries from heat and direct sunlight. Do not dispose of batteries by burning, danger of explosion!
Keep batteries away from children. They are no toys.
Do not force batteries open.
Avoid contact with metal objects (rings, mails, screws, etc.), risk of short circuit!
Short-circuited batteries can heat up and even ignite, risk of burns.
For your own safety cover battery terminals with sticky tape during transport.
In case of battery leakage avoid contact with eyes and mucous membranes. After contact wash your hands, rinse
eyes with clear water and contact physician with persistent troubles.
CAUTION:
Do not use odd battery types or fresh and exhausted batteries.
Do not dispose of batteries with the household trash. Return exhausted batteries to collection points or your dealer.
NOTE:
If the remote control range shortens the batteries are exhausted and must be replaced.
Do not use rechargeable batteries.
Protect batteries from heat and direct sunlight. Do not dispose of batteries by burning, danger of explosion!
Remove exhausted batteries from the device. Remove the batteries during longer periods of non-use to avoid bat-
tery leakage.
Wash thoroughly after coming into contact with battery acid.
4. Before Installation
4.1 Scope of Delivery
After unpacking ensure that the following parts were included:
TV set
Stand and four Phillips screws
Mains cord
Remote control (incl. 2 x 1.5V batteries type LR03 AAA)
User manual
4.2 Assemble Device
Attach the stand with the four Phillips screws.
CAUTION TIPPING HAZARD:
Use two lock bars under the stand to lock the joint to prevent
the TV set from tipping over. Slide the lock bars to LOCK posi-
tion (see Figure).
Remove the protective lm from remote control and TV set, if
attached.
Place the TV set on a stable, level surface. Ensure that the surface
can carry the TV’s weight.
Protect the device from extreme heat and humidity.
Ensure sucient ventilation on all sides. When placed in a wall unit leave at least 20cm on top and 10cm distance at
the sides for ventilation.