Operation Manual
71
ENGLISH
NOTE: Wall mounting
• You can alternatively mount the device with the help of a suitable VESA standard wall bracket (available from dea-
lers) to a suitable wall.
- Gap between holes in millimeters: 100 x 100.
- Thread: M4. The pitch length of the screws may not exceed 10 mm.
• The stand is not tted when mounting to a wall.
• Maintain a clearance of at least 8 cm for ventilation around the device.
• Check the reach of the cable! When mounting the device, make sure that an easily accessible outlet is available
within reach of the power cable.
4.3 Connect Antenna Cable
The TV set festures a tuner to receive TV signals via antenna/cable and DVB-T signals.
CAUTION:
• Connect the antenna cable before connecting to mains power supply.
• DVB-T reception: The device is intended for reception via passive DVB-T antenna.
• Connect the DVB-T antenna to ANT input.
• In the source menu (press
SOURCE
button) select DTV.
Other Antenna Connections
For optimum trouble-free picture quality use a dual shielded 75 ohm antenna cable.
1. Connect a 75 ohm antenna cable to the antenna wall outlet.
2. Connect the other end to antenna input ANT at the rear of the device.
3. In the source menu (press
SOURCE
button) select ATV.
NOTE:
To be able to watch TV you rst have to search for channels (
see “4.5 Initial Installation“ on page 71).
4.4 Power Connection
The power supply is designed for AC 100-240 V~ 50/60 Hz.
• Connect the power supply to the DC 12 V/3 A jack on the TV set. Then plug the power supply into a properly installed
wall socket.
CAUTION:
Connect all devices before connecting the TV set to mains power supply. The wall outlet must be freely accessible at all
times.
4.5 Initial Installation
When turning the TV set on for the rst time a window is displayed to
select the menu language and to start Channel Search.
1. When the indicator light turns red, press the POWER
button on
the remote control. The “Select OSD Language” window is dis-
played.
2. Press OK to conrm German as OSD language or press the arrow
buttons / / / on the remote control and OK to select your
language.
3. Press the arrow buttons / / / to select the country of your location.
4. Press OK to start Channel search. This process will take a few minutes. Progress is displayed on screen.