Operation Manual

English
32
• Mountthebaseplateontothestand.
• Forprotectionofthedevice,placeablanketontoasturdytablethatcansupporttheweightofthetelevision.
• Carefullyplacethescreenofthetelevisionontotheblanket.
• AttachthestandwiththePhillipsscrew.
• RemovetheprotectivelmfromremotecontrolandTVset,ifattached.
• PlacetheTVsetonastable,levelsurface.EnsurethatthesurfacecancarrytheTV’sweight.
• Protectthedevicefromextremeheatandhumidity.
• Ensuresufcientventilationonallsides.Whenplacedinawallunitleaveatleast20cmontopand10cmdistanceat
the sides for ventilation.
NOTE: Wall mounting
• YoucanalternativelymountthedevicewiththehelpofasuitableVESAstandardwallbracket(availablefromdeal-
ers) to a suitable wall.
- Gapbetweenholesinmillimeters:200x100.
- Thread:M4.Thepitchlengthofthescrewsmaynot exceed 10 mm.
• Thestandisnotttedwhenmountingtoawall.
• Maintainaclearanceofatleast8cmforventilationaroundthedevice.
• Check the reach of the cable!Whenmountingthedevice,makesurethataneasilyaccessibleoutletisavailable
within reach of the power cable.
4.3 Connect Antenna Cable
The TV set festures a tuner to receive TV signals via antenna/cable and DVB-T signals.
CAUTION:
• Connecttheantennacablebeforeconnectingtomainspowersupply.
• DVB-T reception: The device is intended for reception via passive DVB-T antenna.
• ConnecttheDVB-TantennatoANT input.
• Inthesourcemenu (press SOURCE button) select DTV.
Other Antenna Connections
Foroptimumtrouble-freepicturequalityuseadualshielded75ohmantennacable.
1. Connecta75ohmantennacabletotheantennawalloutlet.
2. ConnecttheotherendtoantennainputANT at the rear of the device.
3. In the source menu (press SOURCE button) select ATV.
NOTE:
TobeabletowatchTVyoursthavetosearchforchannels(
see “4.5 Initial Installation” on page 32).
4.4 Power Connection
Thetelevisiondeviceissetupforalternatingcurrent100-240V,50/60Hz.
• Plugthepowerplugintoaproperlyinstalledoutlet.
CAUTION:
ConnectalldevicesbeforeconnectingtheTVsettomainspowersupply.Thewalloutletmustbefreelyaccessibleatall
times.
4.5 Initial Installation
WhenturningtheTVsetonforthersttimeawindowisdisplayedto
selectthemenulanguageandtostartChannelSearch.
1. Turn on the device with the power switch, located at the right
bottomofthedevice.Whentheindicatorlightturnsred,pressthe
POWER
buttonontheremotecontrol.The“Pleaseselectan
OSDLanguage”windowisdisplayed.
2. Pressthearrowbuttons / / / on the remote control and OK
toselectyourlanguage.