User manual

WARNINGS:
CHOICE OF ELECTRICAL
CONNECTION
There are three possible ways to connect your
cooker. In each case the cooker should be
operated using at least 6mm
2
twin core and earth
PVC insulated multicore cable. Please choose
from the most appropriate after reading the
different methods:-
a) By connecting the cooker to a cooker point (having
a double pole isolating switch with at least 3mm
contact separation in all poles and neutral) and
protected with a fuse or miniature circuit breaker at
your mains fuse box.
b) By connecting the cooker together with a hob
directly to a cooker point(s). Having a double pole
isolating switch with at least 3mm contact
separation in all poles and neutral.
c) If you wish to connect an oven and a hob to a
cooker point you can by connecting the oven and
hob separately to the cooker point. Oven and hob
units should be separately connected to a control
panel. See Fig. 2.
NOTE: It is good practice to:
Fit an Earth Leakage Circuit Breaker to your house
wiring.
Wire your appliance to the latest IEE regulations.
45
Subject to Regional Electricity Company
regulations if you wish to connect the
oven and hob to the power supply you
may use one of the following two
methods:-
This cooker must be installed by a
qualified electrician/competent
person. Safety may be impaired if
installation is not carried out in
accordance with these instructions.
This cooker must be earthed.
Do not remove the screws from the
earth tab extending from the oven
mains terminal block (Fig.1).
Before connecting the cooker make
sure that the voltage of your
electricity supply is the same as that
indicated on the rating plate. The
rating plate can be seen by opening
the oven door and looking below the
oven door seal.
Do not alter the electrical circuitry of
this cooker.
Fig. 1
Fig. 2